Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM
RM27L0U _53 Suspension _049320 TIRE / WHEEL _0235734 TIRE AND WHEEL SYSTEM G

TIRE / WHEEL  TIRE AND WHEEL SYSTEM  INSPECTION  


PROCEDURE

Hide 1.INSPECT TIRE

a.

Check the tires for wear and proper inflation pressure.

Standard Cold Tire Inflation Pressure
Tire Size Front
kPa (kgf/cm2, psi)
Rear
kPa (kgf/cm2, psi)
P275/65R18 114T 230 (2.3, 33) 230 (2.3, 33)
P275/55R20 111H 210 (2.1, 30) 230 (2.3, 33)
P255/70R18 112T (Spare Tire) 230 (2.3, 33)


b.
R003031

Using a dial indicator, check the tire runout.

Tire runout:

3.0 mm (0.118 in.) or less



Hide 2.ROTATE TIRE

a.
C258067E01
0.544,0.655 0.759,0.844 0.215,0.189 10 *a

Rotate the tires as shown in the illustration.

Torque:
for Aluminum Wheel : 131 N*m (1336 kgf*cm, 97 ft.*lbf)
for Steel Wheel : 209 N*m (2131 kgf*cm, 154 ft.*lbf)

Text in Illustration
*a Front of the Vehicle

NOTICE:

The steel wheel for this vehicle indicates a spare tire.



Hide 3.INSPECT WHEEL BALANCE

a.
C221195E03
0.542,1.24 0.823,1.479 0.281,0.24 10 false (A) 2.031,1.385 2.313,1.625 0.281,0.24 10 false (A)

Check and adjust the off-the-car balance.

NOTICE:
·

Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.

·

Do not touch the sticking surface of the tape.

·

Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

Width (A):

25 mm (0.984 in.)


·

Push the balance weight firmly to adhere it to the position.

·

Do not reuse the balance weight.



HINT:

If necessary, check and adjust the on-the-car balance.