SKID CONTROL ECU
| Terminal No. (Symbol) | Terminal Description |
|---|---|
| 16 (GND1) | Skid control ECU ground |
| 15 (STPO) | Stop light control relay (BRK NO. 1) signal input |
| 14 (PKB2) | Parking brake switch signal input |
| 13 (CANL) | Vehicle CAN communication line |
| 12 (CANH) | Vehicle CAN communication line |
| 11 (EXI2) | Center differential lock detection switch signal input (4WD) |
| 10 (D/G) | Diagnosis tester communication line |
| 9 (BZ)* | Buzzer drive input |
| 8 (IG1) | IG1 power supply |
| 7 (TS) | Sensor check input |
| 6 (STP2) | Stop light switch and stop light control relay (BRK NO. 1) signal input |
| 5 | No pin |
| 4 (CSW) | VSC OFF switch signal input |
| 3 (SP1) | Vehicle speed pulse signal output |
| 2 | No pin |
| 1 (+BM) | Motor relay power supply |
| 31 (BST) | Brake booster solenoid ground |
| 30 (PIM) | Pedal stroke sensor (Delta S sensor) input line |
| 29 (GYAW) | Yaw rate sensor ground |
| 28 | No pin |
| 27 (E3) | Pedal stroke sensor (Delta S sensor) ground |
| 26 (VCP) | Pedal stroke sensor (Delta S sensor) power source |
| 25 | No pin |
| 24 (PSNO) | Brake booster micro switch (Normal Open) signal input |
| 23 (PSNC) | Brake booster micro switch (Normal Close) signal input |
| 22 (VYS) | Yaw rate sensor power source |
| 21 (STS) | Brake booster micro switch power source |
| 20 | No pin |
| 19 (SS2) | Yaw rate sensor signal line |
| 18 (SS1) | Yaw rate sensor signal line |
| 17 (BSTP) | Brake booster solenoid power source |
| 47 | No pin |
| 46 (FL-) | Front wheel LH speed signal line |
| 45 (FL+) | Front wheel LH speed signal line |
| 44 (BSW) | Stop light control relay (BRK NO. 2) drive input |
| 43 (RR+) | Rear wheel RH speed signal line |
| 42 (RR-) | Rear wheel RH speed signal line |
| 41 | No pin |
| 40 (PSOO) | Brake booster micro switch signal output |
| 39 | No pin |
| 38 (STP) | Stop light switch signal input |
| 37 (RL-) | Rear wheel LH speed signal line |
| 36 (RL+) | Rear wheel LH speed signal line |
| 35 | No pin |
| 34 (FR+) | Front wheel RH speed signal line |
| 33 (FR-) | Front wheel RH speed signal line |
| 32 (+BS) | Solenoid relay power supply |
*: w/ Dynamic Radar Cruise Control System
CHECK SKID CONTROL ECU
Disconnect the A19 ECU connector.
Measure the voltage or resistance according to the value(s) in the table below.
Voltage cannot be measured with the connector connected to the skid control ECU as the connector is watertight.
*1: for 4WD
*2: for 2WD
| Terminal No. (Symbol) | Wiring Color | Terminal Description | Condition | Specified Condition |
|---|---|---|---|---|
| A19-16 (GND1) - Body ground | W-B - Body ground | Skid control ECU ground | Always | Below 1 Ω |
| A19-15 (STPO) - Body ground | BR - Body ground | Stop light control relay (BRK NO. 1) signal input | Ignition switch ON | 11 to 14 V |
| A19-14 (PKB2) - Body ground | LG - Body ground | Parking brake switch signal input | Parking brake switch ON | Below 1 Ω |
| A19-12 (CANH) - A19-13 (CANL) | B - W | CAN BUS | Always | 54 to 69 Ω |
| A19-11 (EXI2) - Body ground | GR - Body ground | Center differential lock detection switch signal input (4WD) | Center differential lock detection switch ON | Below 1 Ω |
| A19-10 (D/G) - H19-7 (SIL) | P - BE | Diagnosis tester communication line | Always | Below 1 Ω |
| A19-8 (IG1) - Body ground | V - Body ground | IG1 power supply | Ignition switch ON | 11 to 14 V |
| A19-7 (TS) - H19-12 (TS) | W - G | Sensor check input | Always | Below 1 Ω |
| A19-6 (STP2) - Body ground | GR - Body ground | Stop light switch and stop light control relay (BRK NO. 1) signal input | Brake pedal depressed | 8 to 14 V |
| Brake pedal released | Below 1.5 V | |||
| A19-4 (CSW) - Body ground | P - Body ground | VSC OFF switch signal input | VSC OFF switch ON | Below 1 Ω |
| A19-1 (+BM) - Body ground | L - Body ground | Motor relay power supply | Always | 11 to 14 V |
| A19-31 (BST) - A19-17 (BSTP) | B - V | Brake booster solenoid ground | Always | 1 to 2 Ω |
| A19-30 (PIM) - A19-27 (E3) | R - BE | Pedal stroke sensor (Delta S sensor) input line | Always | 4 to 8 kΩ |
| A19-29 (GYAW) - O12-5 (GYAW)*1 | P - G | Yaw rate sensor ground | Always | Below 1 Ω |
| A19-29 (GYAW) - O11-5 (GYAW)*2 | ||||
| A19-27 (E3) - Body ground | BE - Body ground | Pedal stroke sensor (Delta S sensor) ground | Always | 10 kΩ or higher |
| A19-26 (VCP) - A19-27 (E3) | G - BE | Pedal stroke sensor (Delta S sensor) power source | Always | 150 to 200 Ω |
| A19-24 (PSNO) - A19-21 (STS) | LG - SB | Brake booster micro switch (Normal Open) signal input | Brake pedal depressed | Below 1 Ω |
| A19-22 (VYS) - O12-3 (VYS)*1 | R - R | Yaw rate sensor power source | Always | Below 1 Ω |
| A19-22 (VYS) - O11-3 (VYS)*2 | ||||
| A19-21 (STS) - A19-23 (PSNC) | SB - L | Brake booster micro switch power source | Always | Below 1 Ω |
| A19-19 (SS2) - O12-1 (YAW2)*1 | W - W | Yaw rate sensor signal line | Always | Below 1 Ω |
| A19-19 (SS2) - O11-1 (YAW2)*2 | ||||
| A19-18 (SS1) - O12-2 (YAW1)*1 | B - B | Yaw rate sensor signal line | Always | Below 1 Ω |
| A19-18 (SS1) - O11-2 (YAW1)*2 | ||||
| A19-17 (BSTP) - A19-31 (BST) | V - B | Brake booster solenoid power source | Always | 1 to 2 Ω |
| A19-46 (FL-) - z4-1 | LG - B | Front wheel LH speed signal line | Always | Below 1 Ω |
| A19-45 (FL+) - z4-2 | V - W | Front wheel LH speed signal line | Always | Below 1 Ω |
| A19-44 (BSW) - Body ground | L - Body ground | Stop light control relay (BRK NO. 2) drive input | Ignition switch ON | 11 to 14 V |
| A19-43 (RR+) - z5-2 | B - W | Rear wheel RH speed signal line | Always | Below 1 Ω |
| A19-42 (RR-) - z5-1 | W - B | Rear wheel RH speed signal line | Always | Below 1 Ω |
| A19-40 (PSOO) - A27-36 (STV) | SB - SB | Brake booster micro switch signal line | Always | Below 1 Ω |
| A19-38 (STP) - Body ground | Y - Body ground | Stop light switch signal input | Brake pedal depressed | 8 to 14 V |
| Brake pedal released | Below 1.5 V | |||
| A19-37 (RL-) - z6-1 | P - B | Rear wheel LH speed signal line | Always | Below 1 Ω |
| A19-36 (RL+) - z6-2 | L - W | Rear wheel LH speed signal line | Always | Below 1 Ω |
| A19-34 (FR+) - z3-2 | BE - W | Front wheel RH speed signal line | Always | Below 1 Ω |
| A19-33 (FR-) - z3-1 | G - B | Front wheel RH speed signal line | Always | Below 1 Ω |
| A19-32 (+BS) - Body ground | R - Body ground | Solenoid relay power supply | Always | 11 to 14 V |