BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS
VEHICLE STABILITY CONTROL SYSTEM
- PRECAUTION
- PARTS LOCATION
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING
- CALIBRATION
- TEST MODE PROCEDURE
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECU
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR
- FREEZE FRAME DATA
- FAIL-SAFE CHART
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART
- C1300/62 Malfunction in skid control ECU
- C1310/11 Open or short in active brake booster solenoid circuit.
- C1311/12, C1380/64
- C1336/39 When the vehicle is driven without completion of zero point calibration.
- C1340/47 When the terminal IG1 voltage is between 10 and 14 V, there is an open in the center differential lock...
- C1281/81, C1360/61
- C1370/73 Information relating to engine, transmission, drivetrain or destination stored in ECM does not match...
- C1439/66, C1445/66
- U0073/94, U0100/65, U0114/27, U0123/62, U0124/69, U0126/63
- C1290/66 Steering angle sensor zero point deviates from zero point stored in skid control ECU by 20 degrees or more.
- C1267/28 When one of following conditions is met: 1. Micro switch signal PSNC and PSNO logic malfunction. 2. When...
- C1249/49 When one of following conditions is met: 1. When voltage of STP2 pin is detected to be outside range of 1.4...
- C1247/47 When either condition below is met: 1. When the output becomes 4.7 V or more or 0.2 V or less per 0.1...
- C1241/41 When any of following conditions detected: 1. +BS terminal voltage 18 V or more (momentary occurrence...
- C1232/32, C1234/34, C1244/44, C1279/79
- C1231/31 When any of following conditions detected: 1. The ECU-B1 fuse blows or the ignition switch is turned to ON...
- C1207/37 When all conditions below are met: · Yaw rate sensor is normal. · G sensor lateral operation is normal. ·...
- C1203/53 When all of following conditions detected: 1. Engine variation data from ECM does not match one in skid...
- C1201/51 Engine control system malfunction signal continues for 1.2 seconds.
- C0278/11 Either condition is met: 1. Malfunction in skid control ECU continues for 0.056 seconds or more. 2. Voltage...
- C0273/13, C1251/51
- C0226/21, C0236/22, C0246/23, C0256/24, C1225/25, C1226/26, C1227/27, C1228/28
- C0210/33, C0215/34, C1273/73, C1274/74, C1277/77, C1278/78, C1332/37, C1333/38
- 43
- C0200/31, C0205/32, C1271/71, C1272/72, C1275/75, C1276/76, C1330/35, C1331/36
- ABS Warning Light Remains ON
- ABS Warning Light does not Come ON
- Brake Warning Light Remains ON
- Brake Warning Light does not Come ON
- TRAC OFF Indicator Light Remains ON
- TRAC OFF Indicator Light does not Come ON
- VSC OFF Indicator Light Remains ON
- VSC OFF Indicator Light does not Come ON
- Slip Indicator Light Remains ON
- Slip Indicator Light does not Come ON
- AUTO LSD Indicator Light Remains ON
- AUTO LSD Indicator Light does not Come ON
- Skid Control Buzzer Circuit
- TC and CG Terminal Circuit
- TS and CG Terminal Circuit
- Preparation
BRAKE ACTUATOR
FRONT SPEED SENSOR
REAR SPEED SENSOR
YAW RATE AND DECELERATION SENSOR
STEERING ANGLE SENSOR
SKID CONTROL BUZZER
VSC OFF SWITCH
RELAY