If a malfunction in the engine control system is detected through the CAN, the operations of TRAC are prohibited by the fail-safe function.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| C1201/51 | Engine control system malfunction signal continues for 1.2 seconds. | SFI system |
When replacing the VSC actuator assembly, perform zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).
for 3UR-FE:
Clear the DTC (SFI system) (See page Engine / Hybrid System>3UR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR).
for 3UR-FBE:
Clear the DTC (SFI system) (See page Engine / Hybrid System>3UR-FBE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR).
for 3UR-FE:
Check the DTC (SFI system) (See page Engine / Hybrid System>3UR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR).
for 3UR-FBE:
Check the DTC (SFI system) (See page Engine / Hybrid System>3UR-FBE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTC (SFI system) is not output | A |
| DTC (SFI system) is output (for 3UR-FE) | B |
| DTC (SFI system) is output (for 3UR-FBE) | C |
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B
C