Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › BRAKE ACTUATOR
RM27L0U _54 Brake _049321 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0235736 BRAKE ACTUATOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  BRAKE ACTUATOR  REMOVAL  


PROCEDURE

Hide 1.DISCONNECT VSC ACTUATOR CONNECTOR

a.
C154434

Pull the release bar and disconnect the VSC actuator connector.

NOTICE:

Be careful not to allow brake fluid to enter the removed connector.



Hide 47311 2.REMOVE BRAKE TUBE

a.
U152153E01
0.347,1.407 0.528,1.553 0.181,0.147 10 *2 0.383,2.224 0.544,2.371 0.161,0.147 10 *4 2.573,1.353 2.755,1.518 0.181,0.165 10 *3 1.009,0.437 1.186,0.616 0.177,0.179 10 *5 0.348,0.07 0.533,0.249 0.185,0.179 10 *6 1.485,0.757 1.666,0.923 0.181,0.165 10 *1 1.544,2.203 0.644,1.487 0.644,1.487 0.547,1.487 false 1.714,2.476 0.574,2.316 false 2.052,1.577 2.172,1.434 2.172,1.434 2.556,1.434 false

Use tags or make a note to identify the reconnection locations.

HINT:
·

*1: FR RH

·

*2: FR LH

·

*3: RR RH

·

*4: RR LH

·

*5: FR Master Cylinder

·

*6: RR Master Cylinder




b.
C208906

Using a union nut wrench, disconnect the 2 brake tubes from the VSC actuator.


c.
C208907

Using a union nut wrench, remove the 2 brake tubes from the brake master cylinder.


Hide 47312 3.DISCONNECT BRAKE TUBE

a.
C208908

Using a union nut wrench, disconnect the 4 brake tubes from the VSC actuator.


b.

Remove the clamp from the VSC actuator bracket.


Hide 44540 4.REMOVE VSC ACTUATOR WITH ACTUATOR BRACKET ASSEMBLY

a.
C155484

Remove the 3 nuts and VSC actuator with actuator bracket.

NOTICE:

Do not damage the brake lines or wire harness.