Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › FRONT SPEED SENSOR
RM27L0U _54 Brake _049321 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0235737 FRONT SPEED SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  FRONT SPEED SENSOR  INSTALLATION  


PROCEDURE

Hide 89543 1.INSTALL FRONT SPEED SENSOR LH

C178152

a.

Using a hexagon wrench, install the front speed sensor with the bolt.

Torque:
11 N*m (107 kgf*cm, 8 ft.*lbf)

NOTICE:
·

Make sure that there are no pieces of iron or other foreign matter attached to the sensor tip part.

·

While inserting the speed sensor into the knuckle hole, do not strike or damage the sensor tip part.

·

After installing the speed sensor, make sure that there is no clearance or foreign matter between the sensor stay part and the knuckle.

·

Make sure that there is no foreign matter attached to the magnetic rotor.




b.

Connect the front speed sensor connector.


Hide 42603 2.INSTALL FRONT WHEEL

Torque:
for Aluminum Wheel : 131 N*m (1336 kgf*cm, 97 ft.*lbf)
for Steel Wheel : 209 N*m (2131 kgf*cm, 154 ft.*lbf)

Hide 89543 3.INSPECT SPEED SENSOR SIGNAL