Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › YAW RATE AND DECELERATION SENSOR
RM27L0U _54 Brake _049321 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0235739 YAW RATE AND DECELERATION SENSOR A

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  YAW RATE AND DECELERATION SENSOR  INSTALLATION  


PROCEDURE

Hide 89183A 1.INSTALL YAW RATE SENSOR

a.

Connect the sensor connector (labeled A), and then attach the clamp (labeled B) to the hole of the sensor bracket.


b.

Install the yaw rate sensor with the 2 nuts (labeled C).

Torque:
13 N*m (127 kgf*cm, 9 ft.*lbf)

NOTICE:
·

Make sure that the sensor is oriented correctly.

·

If the sensor is dropped, replace it.

·

Securely connect the connector.

·

When installing the sensor, avoid impacts to the sensor.

C353407E01
1.635,0.698 1.792,0.896 0.156,0.198 10 false C 3.49,0.656 3.646,0.854 0.156,0.198 10 false C 5.063,0.51 5.219,0.708 0.156,0.198 10 false A 5.51,1.115 5.667,1.313 0.156,0.198 10 false B 6.01,2.219 6.385,2.438 0.375,0.219 10 false Front 3.417,1.813 4.292,2.104 0.875,0.292 10 false Arrow Stamp




Hide 58805C 5.INSTALL REAR UPPER CONSOLE PANEL SUB-ASSEMBLY

Hide 58804A 6.INSTALL UPPER CONSOLE PANEL SUB-ASSEMBLY

Hide 33504F 7.INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY

Hide 89183A 8.PERFORM YAW RATE SENSOR ZERO POINT CALIBRATION

a.

Perform the yaw rate sensor zero point calibration (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>CALIBRATION).


Hide 89183A 9.CHECK YAW RATE SENSOR SIGNAL