Home › Steering › POWER ASSIST SYSTEMS › VANE PUMP(for 3UR-FE, 3UR-FBE)
RM27L0U _55 Steering _049326 POWER ASSIST SYSTEMS _0235761 VANE PUMP(for 3UR-FE, 3UR-FBE) G

POWER ASSIST SYSTEMS  VANE PUMP(for 3UR-FE, 3UR-FBE)  INSPECTION  


PROCEDURE

Hide 1.INSPECT VANE PUMP SHAFT AND BUSH IN VANE PUMP FRONT HOUSING

a.
C132029E04
2.952,0.238 2.8,0.238 2.8,0.238 2.587,0.979 false 0.392,1.003 0.602,1.206 0.210,0.203 10 [a] 2.989,0.141 3.199,0.344 0.210,0.203 10 [b]

Using a micrometer, measure the outer diameter [a] of the vane pump shaft.


b.

Using a vernier caliper, measure the inner diameter [b] of the vane pump front housing bush.


c.

Calculate the oil clearance.

Oil clearance = Inner diameter of the bush [b] - Outer diameter of the shaft [a]

Maximum oil clearance:

0.07 mm (0.00276 in.)


If the oil clearance is more than the maximum, replace the vane pump assembly.


Hide 2.INSPECT VANE PUMP ROTOR AND VANE PUMP PLATE

a.
C101977E06
2.479,0.333 3.177,0.573 0.698,0.24 10 false Thickness

Using a micrometer, measure the thickness of the vane pump plates.

Standard thickness:

1.405 to 1.411 mm (0.0553 to 0.0556 in.)


If the thickness is not as specified, replace the vane pump assembly.


b.
C101978E01
0.046,0.03 0.941,0.205 0.895,0.174 10 Feeler Gauge 1.133,0.131 1.414,0.131 1.414,0.131 1.524,0.241 false

Using a feeler gauge, measure the clearance between the side face of the vane pump rotor groove and the vane pump plate.

Maximum clearance:

0.03 mm (0.00118 in.)


If the clearance is more than the maximum, replace the vane pump assembly.


Hide 3.INSPECT PRESSURE PORT UNION

a.

Visually check the pressure port union for fluid leaks. If there is a leak, replace the vane pump assembly.


Hide 4.INSPECT TOTAL PRELOAD

a.

Check that the pump rotates smoothly without abnormal noise.


b.

Temporarily install the service bolt.

Recommended service bolt:
Thread diameter:

10 mm (0.394 in.)

Thread pitch:

1.25 mm (0.0492 in.)

Bolt length:

50 mm (1.97 in.)



c.
C053369E19
1.24,1.125 2.396,1.365 2.396,1.365 2.396,1.5 false 1.948,1.51 2.729,1.688 0.781,0.177 10 false Service Bolt

Using a torque wrench, measure the pumps rotating torque.

Standard rotating torque:

0.3 N*m (3 kgf*cm, 2 in.*lbf) or less


If the rotating torque is not as specified, check the vane pump housing oil seal.