Steering
POWER ASSIST SYSTEMS
POWER STEERING SYSTEM
- PRECAUTION
- PARTS LOCATION
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECU
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR
- FAIL-SAFE CHART
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART
- ON-VEHICLE INSPECTION
- C1544 An abnormal engine speed signal is received.
- C1547 An abnormal vehicle speed signal is received.
- U0073 Control module communication bus off.
- C1231 An abnormal steering angle signal is received.
- C1531 A short or open in the solenoid valve circuit
- Power Steering Warning Light Circuit
- IG Power Source Circuit
- Preparation
VANE PUMP(for 3UR-FE, 3UR-FBE)
POWER STEERING ECU
STEERING COLUMN
POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
- PARTS LOCATION
- SYSTEM DIAGRAM
- SYSTEM DESCRIPTION
- HOW TO PROCEED WITH TROUBLESHOOTING
- CUSTOMIZE PARAMETERS
- PROBLEM SYMPTOMS TABLE
- TERMINALS OF ECU
- DIAGNOSIS SYSTEM
- DTC CHECK / CLEAR
- FREEZE FRAME DATA
- FAIL-SAFE CHART
- DATA LIST / ACTIVE TEST
- DIAGNOSTIC TROUBLE CODE CHART
- B2621 Periodical signal from the specified ECU has stopped.
- B2620 While the auto away/return function, driving position memory function or manual control is in operation, the...
- B2611 Telescopic operation stops within the operation range while operating.
- B2602 When both conditions below are met: · Unlock warning switch signal is OFF. · Ignition switch is turned ON.
- B2624 When either condition below is met: · The auto away function is disabled with the last vehicle speed signal*...
- B2610 Tilt operation stops within the operation range while operating.
- B2603 When operating the tilt and telescopic manual switch, an abnormal voltage value is input to the multiplex...
- Actuator Power Source Circuit
- IG Power Source Circuit