Home › Steering › STEERING COLUMN › POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM
RM27L0U _55 Steering _049327 STEERING COLUMN _0235762 POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM U

STEERING COLUMN  POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM  FAIL-SAFE CHART  


HINT:

If the power voltage to the tilt and telescopic ECU returns to normal within 10 seconds during tilt or telescopic operation, the operation will be resumed. If it returns to normal after 10 seconds have elapsed, the operation restarts when a tilt or telescopic operation signal is again input to the tilt and telescopic ECU.


Fail-Safe Operation
DTC Code Detection Item Fail-safe
B2602 Key Unlock Warning Switch Circuit Malfunction Auto away function stops.
Auto return function:
·

Continues (when the ignition switch is ON).

·

Stops (when the ignition switch is off).


B2603 Tilt and Telescopic Manual Switch Circuit Malfunction Tilt and telescopic operation by manual switch is suspended.
B2610 Tilt Position Sensor or Tilt Motor Circuit Malfunction Tilt operation is suspended.
B2611 Telescopic Position Sensor or Telescopic Motor Circuit Malfunction Telescopic operation is suspended.
B2620 ECU Power Source Circuit Malfunction Tilt and telescopic operation is suspended.
B2624 Speed Signal Malfunction Auto away and/or auto return function stops.

FAIL-SAFE FUNCTION


a.

If a malfunction in the tilt position sensor signal or telescopic position sensor signal occurs while operating the power tilt or power telescopic function, the tilt and telescopic ECU stops the operation of the power tilt and power telescopic steering column system.


b.

If the power voltage to the ECU drops below approximately 8 V while operating the power tilt or power telescopic function, the ECU stops the operation of the power tilt and power telescopic steering column system.


c.

If the tilt and telescopic ECU detects that the motor has locked during the operation of the power tilt or power telescopic function, the ECU stops the operation of the power tilt and power telescopic steering column system.


d.

If the communication of an ECU that is related to the power tilt and power telescopic steering column system is interrupted, the system operates as shown below.



Function Main Body ECU Communication Interruption Outer Mirror Control ECU Communication Interruption Front Power Seat Control Switch LH Communication Interruption All ECUs*1 Communication Interruption
Manual Disable*2 Normal Normal Disable*2
Automatic Away Disable Disable Normal Disable
Automatic Return Disable*3 Disable*3 Normal Disable*3
Memory Disable Disable Disable Disable
Recall Disable*2 Disable Disable Disable

HINT:
·

*1: All ECUs that are related to the power tilt and power telescopic steering column system.

·

*2: The operation is permitted if the ignition switch signal is ON while the signal from the main body ECU is interrupted.

The operation is prohibited if the ignition switch signal is off while the signal from the main body ECU is interrupted.

·

*3: If the signal(s) from the ECU is/are interrupted after the operation has started, the operation will be continued when the ignition switch signal is ON, and prohibited when the ignition switch signal is off.