Home › Steering › STEERING COLUMN › STEERING COLUMN ASSEMBLY(for Power Tilt and Power Telescopic Steering Column)
RM27L0U _55 Steering _049327 STEERING COLUMN _0235764 STEERING COLUMN ASSEMBLY(for Power Tilt and Power Telescopic Steering Column) A

STEERING COLUMN  STEERING COLUMN ASSEMBLY(for Power Tilt and Power Telescopic Steering Column)  REASSEMBLY  


PROCEDURE

Hide 84450 1.INSTALL IGNITION SWITCH ASSEMBLY

a.
C155157

Attach the 2 claws to install the ignition switch to the switch bracket.


Hide 85432 2.INSTALL KEY INTERLOCK SOLENOID

a.
C155158

Install the key interlock solenoid to the switch bracket with the 2 screws.


Hide 84052 3.INSTALL UNLOCK WARNING SWITCH ASSEMBLY

a.
C155156

Attach the 2 claws to install the unlock warning switch to the switch bracket.


Hide 69057A 4.INSTALL IGNITION SWITCH LOCK CYLINDER

a.

Check that the ignition switch lock cylinder is in the ACC position.


b.
C353590E01
2.688,1.198 3,1.396 0.313,0.198 10 false *a 2.375,0.76 2.688,0.958 0.313,0.198 10 false *b 2.458,0.344 2.771,0.542 0.313,0.198 10 false *c 2.927,0.219 3.24,0.417 0.313,0.198 10 false *d

Install the ignition switch lock assembly to the switch bracket.

Text in Illustration
*a LOCK
*b ACC
*c ON
*d START


c.

Check that the ignition switch lock cylinder is securely installed.


Hide 5.INSPECT STEERING LOCK OPERATION

Hide 45271 6.INSTALL UPPER STEERING COLUMN CLAMP WITH SWITCH BRACKET ASSEMBLY

a.

Temporarily install the steering column upper with switch bracket and the steering lock bracket with 2 new tapered-head bolts.


b.
C159756

Tighten the 2 tapered-head bolts until the bolt heads break off.


Hide 89783 7.INSTALL TRANSPONDER KEY COIL

a.

Align the transponder key coil with the installation position of the upper bracket with the coil inclined.


b.
C155160

Push the transponder key coil upward and install it to the switch bracket.

NOTICE:

Do not push the transponder key coil up with excessive force.



Hide 89227 8.INSTALL MULTIPLEX TILT AND TELESCOPIC ECU

a.
C159704

Install the ECU with the 2 screws.

Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)


b.

Connect the 2 ECU connectors.