84250A
1.INSPECT STEERING PAD SWITCH ASSEMBLY
Measure the resistance according to the value(s) in the table below.
| *1 | Right Switch | *2 | Up Switch |
| *3 | Left Switch | *4 | Down Switch |
| *5 | Enter Switch | *6 | Back Switch |
| *7 | Mode Switch | *8 | Volume + Switch |
| *9 | Volume - Switch | *10 | Voice Switch |
| *11 | Off Hook Switch | *12 | On Hook Switch |
| *13 | w/ Distance Control Switch | - | - |
| *a | Component without harness connected | - | - |
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| A10 (AU1) - A8 (EAU) | No switch is pushed | 95 to 105 kΩ |
| Up switch is pushed | Below 2.5 Ω | |
| Down switch is pushed | 313 to 345 Ω | |
| Volume + switch is pushed | 950 to 1050 Ω | |
| Volume - switch is pushed | 2955 to 3265 Ω | |
| A8 (EAU) - A7 (AU3) | No switch is pushed | 95 to 105 kΩ |
| Right switch is pushed | 950 to 1050 Ω | |
| Left switch is pushed | 2955 to 3265 Ω | |
| Enter switch is pushed | Below 2.5 Ω | |
| Back switch is pushed | 313 to 345 Ω | |
| A9 (AU2) - A8 (EAU) | No switch is pushed | 95 to 105 kΩ |
| Mode switch is pushed | Below 2.5 Ω | |
| Off hook switch is pushed | 950 to 1050 Ω | |
| On hook switch is pushed | 313 to 345 Ω | |
| Voice switch is pushed | 2955 to 3265 Ω | |
| A4 (DIST) - A6 (ECC) | No switch is pushed | 95 to 105 kΩ |
| Distance Control switch is pushed | Below 2.5 Ω | |
| B (HO) - A1 (HO) | Always | Below 1 Ω |
If the result is not as specified, replace the steering pad switch assembly.
Check the illumination.
Connect the battery positive (+) lead to terminal A5 (IL+2) and the negative (-) lead to terminal A2 (EAC) of the steering pad switch assembly connector.
Check that the switch illumination comes on.
Steering pad switch illumination comes on.
If the result is not as specified, replace the steering pad switch assembly.