Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
45187
3.REMOVE LOWER NO. 3 STEERING WHEEL COVER
45186
4.REMOVE LOWER NO. 2 STEERING WHEEL COVER
45130
5.REMOVE STEERING PAD
45100
6.REMOVE STEERING WHEEL ASSEMBLY
Disconnect the 2 connectors from the spiral cable.
Remove the steering wheel set nut.
Put matchmarks on the steering wheel and main shaft.
| *a | Matchmark |
| *b | Hold |
| *c | Turn |
Using SST, remove the steering wheel.
45116
7.REMOVE NO. 2 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)
Remove the 2 screws.
Detach the 3 guide pins and claw, and remove the No. 2 steering wheel ornament.
45116
8.REMOVE NO. 1 STEERING WHEEL ORNAMENT (w/o Steering Pad Switch)
Remove the 2 screws.
Detach the 3 guide pins and claw, and remove the No. 1 steering wheel ornament.
84250A
9.REMOVE STEERING PAD SWITCH ASSEMBLY (w/ Steering Pad Switch)
Remove the 4 screws.
Detach the 6 guide pins and 2 claws, and remove the steering pad switch assembly.
84632
10.REMOVE CRUISE CONTROL MAIN SWITCH
Disconnect the connector and remove the harness from cruise control main switch.
Remove the 2 screws and remove the cruise control main switch.
45188
11.REMOVE STEERING WHEEL PAD ATTACHING SCREW
Remove the 2 steering wheel pad attaching screws.