This circuit sends a sound signal from the television display to the headphone terminal.
Check the malfunctioning headphones.
| Result | Proceed to |
|---|---|
| Malfunction in headphone terminal RH side | A |
| Malfunction in headphone terminal LH side | B |
A
B
Disconnect the U13 television display assembly connector.
Disconnect the S7 headphone terminal RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| U13-26 (HP2R) - S7-1 (HP2R) | Always | Below 1 Ω |
| U13-28 (HP2L) - S7-2 (HP2L) | Always | Below 1 Ω |
| U13-27 (SLD6) - S7-3 (SG8) | Always | Below 1 Ω |
| U13-26 (HP2R) - Body ground | Always | 10 kΩ or higher |
| U13-28 (HP2L) - Body ground | Always | 10 kΩ or higher |
| U13-27 (SLD6) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the television display assembly connector still connected (See page Audio / Visual / Telematics>AUDIO / VIDEO>TELEVISION DISPLAY>REMOVAL).
Using an oscilloscope, check the waveform between each terminal and the body ground according to the conditions as shown in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| U13-26 (HP2R) - Body ground | Audio sound being produced | A waveform synchronized with sound is output |
| U13-28 (HP2L) - Body ground |
| *a | Component with harness connected
(Television Display Assembly) |
OK
(See pageAudio / Visual / Telematics>AUDIO / VIDEO>REAR SEAT ENTERTAINMENT SYSTEM>PROBLEM SYMPTOMS TABLE)
NG
Disconnect the U13 television display assembly connector.
Disconnect the S8 headphone terminal LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| U13-12 (HP1R) - S8-1 (HP1R) | Always | Below 1 Ω |
| U13-14 (HP1L) - S8-2 (HP1L) | Always | Below 1 Ω |
| U13-13 (SLD5) - S8-3 (SG7) | Always | Below 1 Ω |
| U13-12 (HP1R) - Body ground | Always | 10 kΩ or higher |
| U13-14 (HP1L) - Body ground | Always | 10 kΩ or higher |
| U13-13 (SLD5) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the television display assembly connector still connected (See page Audio / Visual / Telematics>AUDIO / VIDEO>TELEVISION DISPLAY>REMOVAL).
Using an oscilloscope, check the waveform between each terminal and the body ground according to the conditions as shown in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| U13-12 (HP1R) - Body ground | Audio sound being produced | A waveform synchronized with sound is output |
| U13-14 (HP1L) - Body ground |
| *a | Component with harness connected
(Television Display Assembly) |
OK
(See pageAudio / Visual / Telematics>AUDIO / VIDEO>REAR SEAT ENTERTAINMENT SYSTEM>PROBLEM SYMPTOMS TABLE)
NG