Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049329 AUDIO / VIDEO _0235782 AUDIO AND VISUAL SYSTEM J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM  Data Signal Circuit between Radio Receiver and Stereo Jack Adapter  


DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

E345030E01
1.167,0.688 1.625,0.885 0.458,0.198 10 false UDO- 1.146,1.198 1.604,1.396 0.458,0.198 10 false UDO+ 1.646,0.573 2.104,0.771 0.458,0.198 10 false 2 1.635,1.083 2.094,1.281 0.458,0.198 10 false 3 5.656,0.677 6.115,0.875 0.458,0.198 10 false UDO- 5.656,1.188 6.115,1.385 0.458,0.198 10 false UDO+ 5.458,0.573 5.917,0.771 0.458,0.198 10 false 2 5.458,1.083 5.917,1.281 0.458,0.198 10 false 3 0.583,1.594 1.042,1.792 0.458,0.198 10 false I51 0.583,1.771 1.781,2.219 1.198,0.448 10 false No. 1 Stereo Jack Adapter Assembly 5.5,1.604 5.958,1.802 0.458,0.198 10 false I60 5.5,1.781 6.698,2.229 1.198,0.448 10 false Radio and Display Receiver Assembly

PROCEDURE

1.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)
a.

Disconnect the I60 radio and display receiver assembly connector.


b.

Disconnect the I51 No. 1 stereo jack adapter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I60-2 (UDO-) - I51-2 (UDO-) Always Below 1 Ω
I60-3 (UDO+) - I51-3 (UDO+) Always Below 1 Ω
I60-2 (UDO-) - Body ground Always 10 kΩ or higher
I60-3 (UDO+) - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR