Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049331 PARK ASSIST / MONITORING _0235786 INTUITIVE PARKING ASSIST SYSTEM J

PARK ASSIST / MONITORING  INTUITIVE PARKING ASSIST SYSTEM  Vehicle Speed Signal Circuit  


WIRING DIAGRAM

E280653E06
5.115,1.615 5.688,1.792 0.573,0.177 10 false H128 5.344,0.958 5.917,1.135 0.573,0.177 10 false SPD 5.073,0.844 5.25,1.021 0.177,0.177 10 false 17 1.646,0.969 1.917,1.146 0.271,0.177 10 false +S 1.938,0.833 2.156,1.01 0.219,0.177 10 false 35 5.104,1.781 6.448,2.125 1.344,0.344 10 false Clearance Warning ECU Assembly 0.76,1.615 1.333,1.792 0.573,0.177 10 false H37 0.75,1.781 2.094,2.125 1.344,0.344 10 false Combination Meter Assembly

PROCEDURE

1.CHECK COMBINATION METER ASSEMBLY (SPEED SIGNAL)
a.
U154176E02
1.677,1.417 2.74,1.906 2.74,1.906 2.844,1.906 true 2.823,3.385 3.188,3.542 0.365,0.156 10 false GND 1.563,0.521 1.927,0.677 0.365,0.156 10 false H128 2.906,1.823 3.219,1.979 0.313,0.156 10 false SPD 0.104,2.115 1.115,2.302 1.01,0.188 10 false *b 0.104,0.073 0.354,0.344 0.25,0.271 10 false *a

Disconnect the clearance warning ECU assembly connector.


b.

Using an oscilloscope, check the signal waveform of the combination meter assembly.

Measurement Condition
Item Content
Terminal No. (Symbol) H128-17 (SPD) - Body ground
Tool Setting 5 V/DIV., 20 msec./DIV.
Condition Drive vehicle at 20 km/h (12 mph)

OK:

Refer to the illustration.


HINT:

As the vehicle speed increases, the wave length shortens.


Text in Illustration
*a Front view of wire harness connector
(to Clearance Warning ECU Assembly)
*b Waveform



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - COMBINATION METER ASSEMBLY)
2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - COMBINATION METER ASSEMBLY)
a.

Disconnect the H128 clearance warning ECU assembly connector.


b.

Disconnect the H37 combination meter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H128-17 (SPD) - H37-35 (+S) Always Below 1 Ω
H128-17 (SPD) or H37-35 (+S) - Body ground Always 10 kΩ or higher




OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR