Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049331 PARK ASSIST / MONITORING _0235786 INTUITIVE PARKING ASSIST SYSTEM J

PARK ASSIST / MONITORING  INTUITIVE PARKING ASSIST SYSTEM  Taillight Relay Circuit  


WIRING DIAGRAM

E300596E02
0.49,1.021 1.594,1.375 1.104,0.354 10 false from TAIL Relay 3.313,1.177 3.833,1.365 0.521,0.188 10 false PANEL 5.688,1.01 5.927,1.198 0.24,0.188 10 false TL 5.417,0.906 5.667,1.094 0.25,0.188 10 false 20 5.5,1.823 5.896,1.979 0.396,0.156 10 false H128 5.49,1.99 7.073,2.354 1.583,0.365 10 false Clearance Warning ECU Assembly

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedure.


PROCEDURE

1.CHECK TAILLIGHT
a.

Turn the light control switch to the TAIL position.


b.

Check that the taillight turns on.

OK:

Taillight turns on.




OK

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BATTERY)

NG

2.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - BATTERY)
a.
U154163E02
1.979,1.177 2.5,1.75 2.5,1.75 2.708,1.75 true 1.552,0.229 1.958,0.396 0.406,0.167 10 false H128 0.104,0.042 0.448,0.208 0.344,0.167 10 false *a 2.76,1.667 3.104,1.833 0.344,0.167 10 false TL

Disconnect the clearance warning ECU connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
H128-20 (TL) - Body ground Ignition switch ON,
light control switch TAIL
7 V or higher
Ignition switch ON,
light control switch except TAIL
Below 1.5 V


Text in Illustration
*a Front view of wire harness connector
(to Clearance Warning ECU Assembly)



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR