Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049331 PARK ASSIST / MONITORING _0235786 INTUITIVE PARKING ASSIST SYSTEM J

PARK ASSIST / MONITORING  INTUITIVE PARKING ASSIST SYSTEM  Clearance Warning Buzzer Circuit  


DESCRIPTION

The clearance warning buzzer is installed in the accessory meter assembly.

WIRING DIAGRAM

E300604E02
2.917,1.781 3.99,2.135 1.073,0.354 10 false Accessory Meter Assembly 2.927,1.615 3.188,1.802 0.26,0.188 10 false I22 5.406,1.771 6.635,2.188 1.229,0.417 10 false Clearance Warning ECU Assembly 5.406,1.615 5.792,1.813 0.385,0.198 10 false H128 5.615,0.938 5.917,1.104 0.302,0.167 10 false ER 5.417,0.833 5.615,1.042 0.198,0.208 10 false 2 3.917,0.833 4.115,1.042 0.198,0.208 10 false 11 2.74,0.844 2.938,1.052 0.198,0.208 10 false 23 2.979,0.948 3.25,1.135 0.271,0.188 10 false IG 3.656,0.958 3.927,1.146 0.271,0.188 10 false BZ 1.552,1.094 2.417,1.281 0.865,0.188 10 false ECU-IG No.1 0.156,0.958 1.01,1.313 0.854,0.354 10 false from IG No.1 Relay

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU ASSEMBLY - ACCESSORY METER ASSEMBLY AND BATTERY)
a.

Disconnect the H128 clearance warning ECU assembly connector.


b.

Disconnect the I22 accessory meter assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H128-2 (ER) - I22-11 (BZ) Always Below 1 Ω
H128-2 (ER) or I22-11 (BZ) - Body ground Always 10 kΩ or higher



d.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Switch Condition Specified Condition
I22-23 (IG) - Body ground Ignition switch ON 11 to 14 V




OK

2.CHECK ACCESSORY METER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK ACCESSORY METER ASSEMBLY
a.

Replace the accessory meter assembly with a normally functioning or new one (See page Vehicle Interior>METER / GAUGE / DISPLAY>ACCESSORY METER>REMOVAL).


b.

Check that the clearance warning buzzer operates normally.

OK:

Clearance warning buzzer operates normally.




OK

END (ACCESSORY METER ASSEMBLY IS DEFECTIVE)

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE