Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › BLIND SPOT MONITOR SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049331 PARK ASSIST / MONITORING _0235792 BLIND SPOT MONITOR SYSTEM C

PARK ASSIST / MONITORING  BLIND SPOT MONITOR SYSTEM  C1AB8  Destination Information Undefined  


DESCRIPTION

The blind spot monitor sensor receives the destination information from the main body ECU via CAN communication. This DTC is stored when the blind spot monitor sensor cannot communicate with the main body ECU.

DTC Code DTC Detection Condition Trouble Area
C1AB8 The blind spot monitor sensor cannot communicate with the main body ECU.
·

CAN communication system

·

Main body ECU (cowl side junction block LH)



CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.


PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
a.

Check for DTCs of the CAN communication system (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>DIAGNOSIS SYSTEM).

OK:

CAN communication system DTCs are not output.




OK

2.REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)

NG

2.REPLACE MAIN BODY ECU (COWL SIDE JUNCTION BLOCK LH)
a.

Replace the main body ECU.



NEXT

3.RECHECK DTC
3.RECHECK DTC
a.

Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.




OK

END (MAIN BODY ECU IS DEFECTIVE)

NG