52159
1.REMOVE REAR BUMPER COVER
88172
2.REMOVE BLIND SPOT MONITOR SENSOR LH
Remove the 3 nuts.
Disconnect the connector and remove the blind spot monitor sensor LH.
88162
3.REMOVE BLIND SPOT MONITOR SENSOR RH
Use the same procedure described for the LH side.
88171
4.REMOVE BLIND SPOT MONITOR BRACKET LH
Remove the screw and 2 bolts.
Detach the 2 claws and remove the blind spot monitor bracket LH as shown in the illustration.
Using a clip remover, remove the grommet from the body panel.
The grommet needs to be replaced with a new one because it will break when it is removed.
88161
5.REMOVE BLIND SPOT MONITOR BRACKET RH
Use the same procedure described for the LH side.