Home › Audio / Visual / Telematics › GARAGE DOOR OPENER › GARAGE DOOR OPENER SYSTEM
RM27L0U _56 Audio / Visual / Telematics _049332 GARAGE DOOR OPENER _0235797 GARAGE DOOR OPENER SYSTEM G

GARAGE DOOR OPENER  GARAGE DOOR OPENER SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT GARAGE DOOR OPENER

a.
B165760E01
0.916,1.802 1.954,1.944 1.038,0.142 10 These Switches 2.067,0.688 2.396,0.863 0.330,0.175 10 LED 1.276,1.607 1.538,1.802 1.538,1.802 1.426,1.622 false 1.697,1.65 1.538,1.792 false 1.603,1.538 1.94,0.756 1.94,0.756 2.043,0.756 false

Press each switch and check that the red LED turns on. If one or more of the switches does not turn on the LED, confirm normal operation of the fuse and wire harness. If the fuse and wire harness are malfunctioning, replace them. If not, replace the garage door opener (inner rear view mirror) (See page Vehicle Interior>MIRROR (INT)>INNER REAR VIEW MIRROR>CALIBRATION).


Hide 2.INSPECT GARAGE DOOR OPENER REGISTRATION AND TRANSMITTING

HINT:

Use the "HomeLink" tester and a tester transmitter for this test. First erase the customer's transmitter code, and then register the tester transmitter code.


a.
B166263E05
2.865,1.125 2.865,0.115 2.865,0.115 2.729,0.115 false 1.521,1.823 1.927,1.979 0.406,0.156 10 false Press 1.708,0.052 2.75,0.219 1.042,0.167 10 false Test Transmitter

Check if the test transmitter code was successfully registered.

HINT:

If the code cannot be registered, replace the garage door opener (inner rear view mirror) (See page Vehicle Interior>MIRROR (INT)>INNER REAR VIEW MIRROR>CALIBRATION).



b.
B443218E01
2.521,3.938 2.271,4.365 2.271,4.365 2.146,4.365 false 1.417,1.844 2.188,2.042 0.771,0.198 10 false Press 0.99,4.26 2.198,4.49 1.208,0.229 10 false "Home Link Tester"

Press the garage door opener switch that was registered to the tester transmitter. Check if the "HomeLink" tester's green LED illuminates.

HINT:

If the green LED does not illuminate, replace the garage door opener (inner rear view mirror) (See page Vehicle Interior>MIRROR (INT)>INNER REAR VIEW MIRROR>CALIBRATION).



c.

When the inspection is complete, reregister the customer's transmitter code(s) again.

HINT:
·

Registration of codes for the customer's transmitters may not be possible in the service facility if the customer's transmitters are not available or if any of the buttons are used for rolling code-type systems.

·

Refer to the Owner's Manual for additional information about registration (programming) of transmitter codes.