1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
28800
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION)
51441
3.REMOVE NO. 1 ENGINE UNDER COVER
4.DRAIN ENGINE COOLANT
11209
5.REMOVE V-BANK COVER SUB-ASSEMBLY
16571
6.REMOVE INLET RADIATOR HOSE
16572
7.DISCONNECT OUTLET RADIATOR HOSE
16711
8.REMOVE FAN SHROUD
53736
9.REMOVE FRONT FENDER APRON SEAL RH
44320
10.DISCONNECT VANE PUMP ASSEMBLY
Disconnect the clamp and 2 power steering connectors.
Remove the 2 bolts and disconnect the vane pump.
27020
11.REMOVE GENERATOR ASSEMBLY
Disconnect the generator connector.
Remove the terminal cap and nut, and disconnect the generator wire.
Remove the bolt and disconnect the wire harness bracket from the generator.
Remove the 3 bolts, nut and generator.