Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK
RM27L0U _58 Vehicle Interior _049336 DOOR LOCK _0235808 FRONT DOOR LOCK A

DOOR LOCK  FRONT DOOR LOCK  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The procedure listed below is the LH side.



PROCEDURE

Hide 69310 1.INSTALL FRONT DOOR LOCK

NOTICE:
·

If reusing a door lock that has been removed, replace the packing in the connecting part with new packing.

·

Make sure that no grease or dirt adheres to the packing surface in the connecting part.



a.

Apply MP grease to the sliding and rotating areas of the front door lock.


b.
B192554

Install the front door inside locking cable.


c.
B192553

Engage the 3 claws and close the cover.


d.
B192551

Install the front door lock remote control cable.


e.

Install a new door lock wire harness seal on to the front door lock.


f.

Insert the front door lock open rod into the front door lock, and set it to the front door outside handle frame.


g.

Make sure that the front door lock open rod is securely connected to the front door lock.


h.

Apply adhesive to the threads of the screws.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



i.
B190561

Using a "TORX" socket wrench T30, install the front door lock with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 67403F 2.INSTALL FRONT DOOR FRAME REAR LOWER SUB-ASSEMBLY

Hide 68101 3.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Hide 68141E 4.INSTALL FRONT DOOR GLASS RUN

Hide 67831 5.INSTALL FRONT DOOR SERVICE HOLE COVER

Hide 67625A 6.INSTALL FRONT DOOR TRIM NO. 1 BRACKET

Hide 67601 7.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74231 8.INSTALL FRONT ARMREST BASE UPPER PANEL

Hide 69283 9.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

Hide 67491A 10.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 67491A 11.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH (for 14 Speakers)

Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).