Use the same procedure for the LH side and RH side.
The procedure listed below is the LH side.
1. PRECAUTION
may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67491A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
67491A
4.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (for 14 Speakers)
69283
5.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
74231
6.REMOVE FRONT ARMREST BASE UPPER PANEL
67601
7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
67625A
8.REMOVE FRONT DOOR TRIM NO. 1 BRACKET
67831
9.REMOVE FRONT DOOR SERVICE HOLE COVER
68141E
10.REMOVE FRONT DOOR GLASS RUN
68101
11.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
67403F
12.REMOVE FRONT DOOR FRAME REAR LOWER SUB-ASSEMBLY
69310
13.REMOVE FRONT DOOR LOCK
Using a "TORX" socket wrench T30, remove the 3 screws.
Slide the front door lock downward, pull out the front door lock open rod from the outside handle frame, and remove the front door lock and cables as a unit.
Remove the door lock wire harness seal from the front door lock.
Remove the front door lock remote control cable.
Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and open the cover.
Remove the front door inside locking cable.