Home › Vehicle Exterior › DOOR / HATCH › FRONT DOOR
RM27L0U _59 Vehicle Exterior _049349 DOOR / HATCH _0235958 FRONT DOOR A

DOOR / HATCH  FRONT DOOR  DISASSEMBLY  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the RH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67491A 3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (for 14 Speakers)

a.
B190538

Disengage the 3 clips and remove the front door lower frame bracket garnish.


b.

Disconnect the connector.


Hide 67491A 4.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH

a.
B194240

Disengage the 3 clips and remove the front door lower frame bracket garnish.


Hide 69283 5.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

a.
B190539

Using a moulding remover, disengage the 4 claws and remove the front door inside handle bezel plug.


Hide 74231 6.REMOVE FRONT ARMREST BASE UPPER PANEL

a.
B190537

Disengage the 2 clips and 5 claws and remove the front armrest base upper panel.


b.

Disconnect the connector.


Hide 67601 7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

B190541

a.

Remove the front door armrest cover.


b.

Remove the 2 screws.


c.
B190542

Disengage the 10 clips.


d.

Disconnect the connector.


e.
B190543

Disconnect the front door lock remote control cable and front door inside locking cable and remove the front door trim board sub-assembly.


Hide 84927 8.REMOVE SEAT MEMORY SWITCH (for Driver Side with Memory)

Hide 69277B 9.REMOVE FRONT DOOR INSIDE HANDLE BEZEL

a.
B190544

Remove the 4 screws and remove the front door inside handle bezel.


Hide 69205 10.REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY

a.
B190545

Remove the 3 screws and remove the front door inside handle sub-assembly.


Hide 68171B 11.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP

a.
B195434

Raise the 8 claws of the front door glass inner weatherstrip and then remove the front door glass inner weatherstrip from the front door trim board sub-assembly, as shown in the illustration.


Hide 86160 13.REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

Hide 87901B 14.REMOVE OUTER REAR VIEW MIRROR ASSEMBLY

Hide 68160C 15.REMOVE FRONT DOOR GLASS OUTER WEATHERSTRIP ASSEMBLY

Hide 89430 16.REMOVE OUTER MIRROR CONTROL ECU ASSEMBLY (for Driver Side with Memory)

a.
B192565

Disconnect the 2 connectors.


b.

Remove the 2 screws and remove the outer mirror control ECU assembly.


Hide 67625A 17.REMOVE FRONT DOOR NO. 1 TRIM BRACKET

a.
B190549

Remove the 2 screws and remove the front door No. 1 trim bracket.


Hide 67831 18.REMOVE FRONT DOOR SERVICE HOLE COVER

a.
B190551

Disconnect the connectors and disengage the clamps.


b.
B195025

Remove the front door service hole cover.

NOTICE:

Remove any tape remaining on the door side.



Hide 68141E 19.REMOVE FRONT DOOR GLASS RUN

a.
B190552

Remove the front door glass run.


Hide 68101 20.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

B190553

a.

Provisionally install the power window switch.


b.

Move the front door glass until the 2 bolts can be seen through the service holes.


c.

Remove the 2 bolts.

NOTICE:

Do not drop or damage the front door glass subassembly when removing the bolts.



d.
B195026

Remove the front door glass sub-assembly in the direction indicated by the arrows in the illustration.

NOTICE:

Do not damage the front door glass subassembly.



e.

Remove the power window switch.


Hide 69801 21.REMOVE FRONT DOOR WINDOW REGULATOR SUB-ASSEMBLY

a.
B190554E02
1.521,0.292 1.667,0.49 0.146,0.198 10 true A

Disconnect the connector.


b.

Loosen bolt A.


c.

Remove the 5 bolts, then remove the front door window regulator sub-assembly.

NOTICE:

Do not drop or damage the front door window regulator sub-assembly when removing the bolts.


HINT:

Remove the front door window regulator sub-assembly through the service hole.



Hide 67401F 22.REMOVE FRONT DOOR FRAME FRONT LOWER SUB-ASSEMBLY

a.
B190555

Remove the 2 bolts and remove the front door frame front lower sub-assembly.

NOTICE:

Do not drop or damage the front door frame front lower sub-assembly when removing the bolt.



Hide 67403F 23.REMOVE FRONT DOOR FRAME REAR LOWER SUB-ASSEMBLY

a.
B190556

Remove the 2 bolts and remove the front door frame rear lower sub-assembly.

NOTICE:

Do not drop or damage the front door frame rear lower sub-assembly when removing the bolt.



Hide 67923 24.REMOVE FRONT NO. 1 DOOR STIFFENER CUSHION

a.
B190557

Disengage the 2 clips and remove the front No. 1 door stiffener cushion.


Hide 68610B 25.REMOVE FRONT DOOR CHECK ASSEMBLY

a.
B190558

Remove the 2 nuts and bolt and remove the front door check assembly.


Hide 67861 26.REMOVE FRONT DOOR WEATHERSTRIP

a.
B190559

Disengage the 39 clips and remove the front door weatherstrip.


Hide 67855B 27.REMOVE FRONT DOOR PANEL PROTECTOR

a.
B190560

Disengage the 8 clips and remove the front door panel protector.


Hide 69217E 28.REMOVE FRONT DOOR OUTSIDE HANDLE COVER

a.
B190562

Remove the hole plug.


b.

Using "TORX" socket wrench T30, loosen the screw and remove the front door outside handle cover.


Hide 69052 29.REMOVE DOOR LOCK CYLINDER (for Driver Side)

a.
B190567

Disengage the 2 claws and remove the door lock cylinder.


Hide 69310 30.REMOVE FRONT DOOR LOCK

Hide 69210 31.REMOVE FRONT DOOR OUTSIDE HANDLE ASSEMBLY

a.
B190563

Remove the front door handle assembly by sliding and pulling it in the direction indicated by the arrow mark in the illustration.


Hide 69242F 32.REMOVE FRONT DOOR OUTSIDE HANDLE REAR PAD

a.
B190565

Disengage the 2 claws and remove the front door outside handle rear pad.


Hide 69241H 33.REMOVE FRONT DOOR OUTSIDE HANDLE FRONT PAD

a.
B190566

Disengage the 3 claws and remove the front door outside handle front pad.


Hide 69201A 34.REMOVE FRONT DOOR OUTSIDE HANDLE FRAME SUB-ASSEMBLY

a.
B190568

Using "TORX" socket wrench T30, loosen the screw.


b.

Disengage the claw and slide the front door outside handle frame sub-assembly to remove it.


Hide 35.REMOVE CUSHION

a.
B190570

Remove the cushions from the door panel.