Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK
RM27L0U _58 Vehicle Interior _049336 DOOR LOCK _0235809 REAR DOOR LOCK A

DOOR LOCK  REAR DOOR LOCK  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The procedure listed below is the LH side.



PROCEDURE

Hide 69050A 1.INSTALL REAR DOOR LOCK

NOTICE:
·

If reusing a door lock that has been removed, replace the packing in the connecting part with new.

·

Make sure that no grease or dirt adheres to the packing surface in the connecting part.



a.

Apply MP grease to the sliding and rotating areas of the front door lock.


b.
B192550

Install the rear door inside locking cable.


c.
B192549

Engage the 3 claws and close the cover.


d.
B192547

Install the rear door lock remote control cable.


e.
B192546

Engage the claw and close the cover.


f.

Install a new door lock wire harness seal on to the rear door lock.


g.
B192117

Insert the rear door lock into the rear door outside handle release plate, and set it to the rear door panel.


h.

Make sure that the rear door outside handle frame lock.


i.

Apply adhesive to the threads of the screws.

Adhesive:

Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent



j.

Using a "TORX" socket wrench T30, install the rear door lock with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 68103 2.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 67407F 3.INSTALL REAR DOOR WINDOW FRAME REAR LOWER SUB-ASSEMBLY

Hide 68152C 4.INSTALL REAR DOOR GLASS RUN

Hide 67841E 5.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 67625D 6.INSTALL REAR DOOR TRIM NO. 2 BRACKET

Hide 67603 7.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 69283A 8.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 74271A 9.INSTALL REAR DOOR ARMREST BASE UPPER PANEL

Hide 67673A 10.INSTALL REAR DOOR FRAME GARNISH

Hide 11.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).