Home › Vehicle Interior › METER / GAUGE / DISPLAY › COMBINATION METER
RM27L0U _58 Vehicle Interior _049339 METER / GAUGE / DISPLAY _0235843 COMBINATION METER A

METER / GAUGE / DISPLAY  COMBINATION METER  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>DIAGNOSIS SYSTEM).


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67914B 3.REMOVE FRONT DOOR SCUFF PLATE LH

Hide 55046A 6.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 55410C 7.REMOVE INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY

Hide 83100 8.REMOVE COMBINATION METER ASSEMBLY

a.
B357493

Remove the 4 screws and combination meter assembly.


b.
E141678

Disconnect the connector and detach the wire harness clamp.