The combination meter communicates with the skid control ECU via the CAN line.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| U0129 | When either of following conditions is detected:
·
15 seconds have elapsed since engine started and IG voltage 10.5 V or more ·
No communication with skid control ECU continues for 3 seconds or more (No communication with ECM or skid control ECU continues for 60 seconds or more) |
CAN communication system |
Use the Techstream to check if the CAN communication system is functioning normally (See page Vehicle Interior>METER / GAUGE / DISPLAY>METER / GAUGE SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| CAN communication system DTC is not output | A |
| CAN communication system DTC is output | B |
If the CAN communication system DTC U0129 and another DTC are output at the same time, perform troubleshooting for the CAN communication system DTC U0129 first.
A
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
B