Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › AIRBAG SYSTEM
RM27L0U _58 Vehicle Interior _049341 SUPPLEMENTAL RESTRAINT SYSTEMS _0235848 AIRBAG SYSTEM D

SUPPLEMENTAL RESTRAINT SYSTEMS  AIRBAG SYSTEM  DTC CHECK / CLEAR  


CHECK DTC (Using SST Check Wire)


a.
H102392E73
0.035,0.015 1.372,0.206 1.336,0.191 10 Front view of DLC3: 0.821,1.875 1.116,2.031 0.295,0.156 10 CG 2.044,1.875 2.283,2.031 0.239,0.156 10 TC 1.799,1.453 2.133,1.861 false 1.566,1.05 0.976,1.875 false

Check the DTCs (Present trouble code).

i.

Turn the ignition switch to ON, and wait for approximately 60 seconds.


ii.

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST
09843-18040  

NOTICE:

Connect the terminals to the correct positions to avoid a malfunction.




b.

Check the DTCs (Past trouble code).

i.

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.

SST
09843-18040  

NOTICE:

Connect the terminals to the correct positions to avoid a malfunction.



ii.

Turn the ignition switch to ON, and wait for approximately 60 seconds.



c.

Read the DTCs.

C353456E01
0.125,0.469 2.875,0.667 2.75,0.198 10 false Normal System Code 0.104,0.708 4.385,0.906 4.281,0.198 10 false (without Past Trouble Code): 0.677,1.104 2.51,1.302 1.833,0.198 10 false 0.25 seconds 0.823,1.896 2.656,2.094 1.833,0.198 10 false 0.25 seconds 2.479,1.375 2.792,1.573 0.313,0.198 10 false on 0.104,1.344 0.417,1.542 0.313,0.198 10 false on 0.094,1.75 0.406,1.948 0.313,0.198 10 false off 2.469,1.75 2.781,1.948 0.313,0.198 10 false off 2.646,0.458 5.396,0.656 2.75,0.198 10 false Normal System Code 2.615,0.698 5.365,0.896 2.75,0.198 10 false (with Past Trouble Code): 3.198,1.167 5.031,1.365 1.833,0.198 10 false 0.75 seconds 3.385,1.917 5.219,2.115 1.833,0.198 10 false 0.25 seconds 4.563,0.542 7.156,0.771 2.594,0.229 10 false Trouble Code (Example Codes 11 and 31): 5.083,1.01 5.542,1.208 0.458,0.198 10 false 0.5 5.667,1.927 6.125,2.125 0.458,0.198 10 false 0.5 5.448,1 5.906,1.198 0.458,0.198 10 false 2.5 5.177,1.927 5.635,2.125 0.458,0.198 10 false 1.5 6.281,0.99 6.74,1.188 0.458,0.198 10 false 4.0 6.615,1.927 7.073,2.125 0.458,0.198 10 false Repeat 6.458,2.125 7.104,2.313 0.646,0.188 10 false (seconds) 5.073,2.156 5.99,2.354 0.917,0.198 10 false DTC 11 5.708,2.156 6.625,2.354 0.917,0.198 10 false DTC 31

i.

Read the blinking patterns of the DTCs. As examples, the blinking patterns for the normal system code and trouble codes 11 and 31 are shown in the illustration.

·

Normal system code indication (without past trouble code)

The light blinks twice per second.

·

Normal system code indication (with past trouble code)

When the past trouble code is stored in the center airbag sensor, the light blinks only once per second.

·

Trouble code indication

The first blink indicates the first DTC. The second blinks occurs after a 1.5-second pause.


If there is more than 1 code, there will be a 2.5-second pause between each code. After all codes are shown, there will be a 4.0-second pause, and then all codes will be repeated.

HINT:
·

If 2 or more malfunctions are found, the indication begins with the smaller-numbered code.

·

If DTCs are indicated without connecting the terminals, proceed to "Diagnosis Circuit" (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>Diagnosis Circuit).






CLEAR DTC (Using SST Check Wire)


a.

When the ignition switch is turned off, the DTCs are cleared.

HINT:

Depending on the DTC, the code may not be cleared by turning the ignition switch off. In this case, proceed to the next procedure.



b.

Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3, and then turn the ignition switch to ON.

SST
09843-18040  


c.

Disconnect terminal TC of the DLC3 within 3 to 10 seconds after the DTCs are output, and check if the SRS warning light comes on after 3 seconds.


d.

Within 2 to 4 seconds after the SRS warning light comes on, connect terminals 13 (TC) and 4 (CG) of the DLC3.


e.

The SRS warning light should go off within 2 to 4 seconds after connecting terminals 13 (TC) and 4 (CG) of the DLC3. Then, disconnect terminal 13 (TC) within 2 to 4 seconds after the SRS warning light goes off.


f.

The SRS warning light comes on again within 2 to 4 seconds after disconnecting terminal 13 (TC). Then, reconnect terminals 13 (TC) and 4 (CG) within 2 to 4 seconds after the SRS warning light comes on.


g.

Check if the SRS warning light goes off within 2 to 4 seconds after connecting terminals 13 (TC) and 4 (CG) of the DLC3. Also check if the normal system code is output within 1 second after the SRS warning light goes off.

If DTCs are not cleared, repeat this procedure until the codes are cleared.

C109537E42
0.313,0.521 1.271,0.708 0.958,0.188 10 false Ignition Switch 0.302,1.177 1.542,1.365 1.24,0.188 10 false DLC3 (TC and CG) 0.292,1.875 1.698,2.083 1.406,0.208 10 false SRS Warning Light* 3.708,1.667 3.948,1.875 0.24,0.208 10 false 0.5 0.417,2.323 1.719,2.5 1.302,0.177 10 false T1: Preparation time 0.427,2.646 2.323,2.854 1.896,0.208 10 false T2: approximately 6 seconds 0.438,2.99 1.625,3.188 1.188,0.198 10 false T3: 3 to 5 seconds 0.438,3.333 1.698,3.542 1.26,0.208 10 false T4: 3 to 10 seconds 0.438,3.688 1.625,3.865 1.188,0.177 10 false T5: 2 to 4 seconds 0.438,4 1.625,4.177 1.188,0.177 10 false T6: 1 to 5 seconds 0.438,4.292 1.75,4.479 1.313,0.188 10 false T7: within 1 second 2.281,4.198 6.792,4.438 4.51,0.24 10 false *: The past DTC in the illustration shows DTC 21 as an example. 2.448,3.302 2.646,3.531 0.198,0.229 10 false T1 5.969,3.292 6.198,3.521 0.229,0.229 10 false T7 5.448,3.292 5.646,3.521 0.198,0.229 10 false T6 5.198,3.292 5.385,3.521 0.188,0.229 10 false T5 3.719,3.302 3.938,3.531 0.219,0.229 10 false T4 3.25,3.313 3.469,3.542 0.219,0.229 10 false T3 2.854,3.313 3.094,3.542 0.24,0.229 10 false T2 4.938,3.292 5.125,3.521 0.188,0.229 10 false T6 5.708,3.292 5.896,3.521 0.188,0.229 10 false T5 4.417,3.292 4.604,3.521 0.188,0.229 10 false T6 4.688,3.292 4.875,3.521 0.188,0.229 10 false T5 4.177,3.292 4.406,3.521 0.229,0.229 10 false T5 3.281,1.677 3.51,1.885 0.229,0.208 10 false 0.5 1.844,0.427 2.094,0.625 0.25,0.198 10 false ON 1.844,0.865 2.281,1.063 0.438,0.198 10 false off 1.813,1.573 2.208,1.76 0.396,0.188 10 false Short 1.813,1.198 2.229,1.375 0.417,0.177 10 false Open 1.823,1.958 2.083,2.125 0.26,0.167 10 false on 1.833,2.292 2.156,2.469 0.323,0.177 10 false off 3.75,2.646 3.99,2.854 0.24,0.208 10 false 1.5 6.052,3.771 6.792,3.979 0.74,0.208 10 false (seconds) 6.281,1.677 6.573,1.885 0.292,0.208 10 false 0.25 5.865,1.688 6.167,1.896 0.302,0.208 10 false 0.25



CHECK DTC (Using Techstream)


a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / SRS Airbag / Trouble Codes /



CLEAR DTC (Using Techstream)


a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / SRS Airbag / Trouble Codes /


e.

Clear the DTCs.