Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › CURTAIN SHIELD AIRBAG ASSEMBLY
RM27L0U _58 Vehicle Interior _049341 SUPPLEMENTAL RESTRAINT SYSTEMS _0235852 CURTAIN SHIELD AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  CURTAIN SHIELD AIRBAG ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 62180A 1.INSTALL CURTAIN SHIELD AIRBAG ASSEMBLY

a.

Engage the 11 claws and 2 clamps and install the curtain shield airbag.

B191428


b.

Install the 14 bolts.

Torque:
11 N*m (110 kgf*cm, 8 ft.*lbf)

NOTICE:

Do not twist the curtain shield airbag when installing it.



c.

Connect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



Hide 63310 2.INSTALL ROOF HEADLINING ASSEMBLY

a.

Refer to the procedures from "Install Roof Headlining Assembly" (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>INSTALLATION).


Hide 3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

Hide 4.INSPECT SRS WARNING LIGHT