Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SIDE AIRBAG SENSOR
RM27L0U _58 Vehicle Interior _049341 SUPPLEMENTAL RESTRAINT SYSTEMS _0235857 SIDE AIRBAG SENSOR A

SUPPLEMENTAL RESTRAINT SYSTEMS  SIDE AIRBAG SENSOR  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).


HINT:

The procedure described below is for the RH side. Use the same procedure for both the RH and LH sides, unless otherwise specified.


PROCEDURE

Hide 89860A 1.INSTALL SIDE AIRBAG SENSOR ASSEMBLY

a.

Confirm that the ignition switch is turned off.


b.

Confirm that the cable is disconnected from the battery negative (-) terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.



c.
B194501E01
1.219,4.02 2.138,4.192 0.919,0.172 10 Outer Housing 1.162,4.111 0.983,3.942 false

Engage the guide and install the airbag sensor with the bolt.

Torque:
9.0 N*m (92 kgf*cm, 80 in.*lbf)

NOTICE:
·

Do not use a side airbag sensor that has been dropped.

·

Do not subject the side airbag sensor to any impact or force.




d.

Confirm that there is no looseness by shaking the side airbag sensor.


e.

Connect the airbag connector.


Hide 67601 2.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74231 3.INSTALL FRONT ARMREST BASE UPPER PANEL

Hide 69283 4.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

Hide 67491A 5.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 67491A 6.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH (for 14 Speakers)

Hide 7.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

CAUTION:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

Hide 8.INSPECT SRS WARNING LIGHT