Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (See page Vehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION).
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
67491A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
67491A
4.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH (for 14 Speakers)
69283
5.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG
74231
6.REMOVE FRONT ARMREST BASE UPPER PANEL
67601
7.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
89860A
8.REMOVE SIDE AIRBAG SENSOR ASSEMBLY
Confirm that the cable is disconnected from the battery negative (-) terminal. Even an impact to only the airbag sensor will cause the airbag to deploy.
Slide the outer housing and disconnect the airbag connector.
Remove the bolt.
Disengage the guide and remove the side airbag sensor.