Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY
RM27L0U _58 Vehicle Interior _049341 SUPPLEMENTAL RESTRAINT SYSTEMS _0235858 FRONT PASSENGER AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 73960A 1.INSTALL FRONT PASSENGER AIRBAG ASSEMBLY

a.
B385262E01
0.192,1.479 0.372,1.647 0.180,0.168 10 *1 2.643,1.301 2.823,1.469 0.180,0.168 10 *2 2.489,1.158 2.634,1.379 false 2.645,0.093 2.826,0.261 0.180,0.168 10 *1

Engage the 10 hooks to install the front passenger airbag assembly.

Text in Illustration
*1 Hook
*2 Wire Harness Clamp


b.

Engage the wire harness clamp.


c.

Install the 2 screws.


Hide 82143C 2.REMOVE NO. 3 INSTRUMENT PANEL WIRE

a.
B385264E01
1.632,1.104 1.831,1.277 0.199,0.173 10 *1 1.814,1.192 2.205,1.192 2.205,1.192 2.443,0.897 false

Attach the wire harness clamp to install the No. 3 instrument panel wire.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



b.

Connect the airbag connector and push the connector lock.

Text in Illustration
*1 Connector Lock


Hide 82142A 3.REMOVE NO. 2 INSTRUMENT PANEL WIRE

a.
B385263E01
1.795,0.982 1.992,1.152 0.198,0.170 10 *1 1.987,1.068 2.308,1.068 2.308,1.068 2.547,0.797 false

Attach the wire harness clamp to install the No. 2 instrument panel wire.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.



b.

Connect the airbag connector and push the connector lock.

Text in Illustration
*1 Connector Lock

NOTICE:

Be sure to only connect the connectors to each corresponding color.


HINT:

Use the same procedure to connect the airbag connector on the other side.



Hide 55301 5.INSTALL INSTRUMENT PANEL SUB-ASSEMBLY

a.

Install the instrument panel sub-assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>INSTALLATION).


Hide 6.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

Hide 7.INSPECT SRS WARNING LIGHT