Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › KNEE AIRBAG ASSEMBLY(w/ Passenger Side Knee Airbag)
RM27L0U _58 Vehicle Interior _049341 SUPPLEMENTAL RESTRAINT SYSTEMS _0235861 KNEE AIRBAG ASSEMBLY(w/ Passenger Side Knee Airbag) A

SUPPLEMENTAL RESTRAINT SYSTEMS  KNEE AIRBAG ASSEMBLY(w/ Passenger Side Knee Airbag)  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67913B 3.REMOVE FRONT DOOR SCUFF PLATE RH

Hide 62111C 4.REMOVE COWL SIDE TRIM BOARD RH

Hide 55607 6.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 73990 8.REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

a.
B226007

Remove the 3 bolts and remove the instrument panel airbag.


b.

Disconnect the connector.

NOTICE:

When handling the airbag connector, take care not to damage the airbag wire harness.