Wear protective gloves. Sharp areas on the parts may injure your hands.
Use the same procedure for the LH side and RH side.
The procedure listed below is for the RH side.
1.REMOVE REAR NO. 1 SEAT ASSEMBLY RH
Remove the rear No. 1 seat assembly (See page Vehicle Interior>SEAT>REAR NO. 1 SEAT ASSEMBLY>REMOVAL).
72572B
2.REMOVE RECLINING ADJUSTER KNOB CAP RH
72735
3.REMOVE REAR SEAT RECLINING RELEASE LEVER
71692H
4.REMOVE REAR SEAT CUSHION HINGE COVER NO. 3
71691H
5.REMOVE REAR SEAT CUSHION HINGE COVER NO. 2
6.REMOVE REAR NO. 1 SEAT CUSHION ASSEMBLY RH
7.REMOVE SEAT CUSHION COVER WITH PAD
71075S
8.REMOVE SEPARATE TYPE REAR SEAT CUSHION COVER
87510P
9.REMOVE SEAT CUSHION HEATER ASSEMBLY
Cut off the tack pins which fasten the seat heater to the seat cushion cover, and then remove the seat cushion heater from the seat cushion cover.