Home › Vehicle Interior › SEAT › REAR POWER SEAT CONTROL SYSTEM
RM27L0U _58 Vehicle Interior _049342 SEAT _0235879 REAR POWER SEAT CONTROL SYSTEM J

SEAT  REAR POWER SEAT CONTROL SYSTEM  Rear Door Courtesy Switch Circuit  


DESCRIPTION

The fold seat control ECU receives signals from the rear door courtesy switch and detects the state of the rear door (open/close). If the ECU does not detect that the rear door is open, the seat folding and return functions are not available.

WIRING DIAGRAM

B195054E03
5.615,0.76 5.906,0.906 0.292,0.146 10 false O34 5.198,0.771 5.479,0.927 0.281,0.156 10 false P20 5.99,0.76 6.354,0.917 0.365,0.156 10 false R CL 5.646,3.083 7.094,3.25 1.448,0.167 10 false Fold Seat Control ECU 5.281,0.563 5.385,0.708 0.104,0.146 10 false 4 5.708,0.563 5.813,0.708 0.104,0.146 10 false 4 5.677,0.99 5.833,1.146 0.156,0.156 10 false *1 5.25,0.979 5.417,1.135 0.167,0.156 10 false *2 2.917,0.656 3.021,0.813 0.104,0.156 10 false 1 1.354,1.292 1.688,1.479 0.333,0.188 10 false P7*2 0.198,2.979 0.979,3.135 0.781,0.156 10 false *1: LH Side 0.198,3.26 0.979,3.417 0.781,0.156 10 false *2: RH Side 3.396,2.229 5.01,2.531 1.615,0.302 10 false to Main Body ECU 1.354,1.125 1.698,1.313 0.344,0.188 10 false O7*1 1.354,1.448 3.344,1.656 1.99,0.208 10 false Rear Door Courtesy Light Switch

PROCEDURE

1.READ VALUE USING TECHSTREAM (REAR DOOR COURTESY SWITCH)
a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream ON.


d.

Enter the following menus: Body Electrical / Main Body / Data List.


e.

According to the display on the Techstream, read the Data List.

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
RL Door Courtesy SW Rear door courtesy light switch LH signal / ON or OFF ON: Rear door courtesy light switch LH ON
OFF: Rear door courtesy light switch LH OFF
-
RR Door Courtesy SW Rear door courtesy light switch RH signal / ON or OFF ON: Rear door courtesy light switch RH ON
OFF: Rear door courtesy light switch RH OFF
-

OK:

When rear door courtesy light switch operation is performed, the results are the same as above.




OK

2.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH - FOLD SEAT CONTROL ECU)

NG

GO TO REAR DOOR COURTESY SWITCH CIRCUIT

2.CHECK HARNESS AND CONNECTOR (REAR DOOR COURTESY LIGHT SWITCH - FOLD SEAT CONTROL ECU)
a.

Disconnect the O7 or P7 switch connector.


B443198E01
0.656,1.406 1,1.594 0.344,0.188 0.656,1.677 1,1.865 0.344,0.188 3.323,1.385 3.667,1.573 0.344,0.188 3.323,1.667 3.667,1.854 0.344,0.188 4.573,1.635 4.229,1.146 true 0.208,0.135 2.479,0.49 2.271,0.354 10 false Front view of wire harness connector: (to Rear Door Courtesy Light Switch) 4.063,0.135 6.333,0.49 2.271,0.354 10 false Front view of wire harness connector: (to Fold Seat Control ECU) 0.729,1.417 0.958,1.604 0.229,0.188 10 false O7 0.729,1.688 0.958,1.875 0.229,0.188 10 false P7 1.073,1.698 1.302,1.885 0.229,0.188 10 false *2 1.063,1.417 1.292,1.604 0.229,0.188 10 false *1 3.927,2.167 4.635,2.354 0.708,0.188 10 false *1: LH Side 3.938,2.438 4.688,2.625 0.75,0.188 10 false *2: RH Side 3.906,1.01 4.25,1.198 0.344,0.188 10 false R CL 3.354,1.396 3.646,1.573 0.292,0.177 10 false O34 3.365,1.677 3.656,1.854 0.292,0.177 10 false P20 3.729,1.406 3.958,1.594 0.229,0.188 10 false *1 3.74,1.677 3.969,1.865 0.229,0.188 10 false *2

b.

Disconnect the O34 or P20 ECU connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
LH Side
Tester Connection Condition Specified Condition
O7-1 - O34-4 (R CL) Always Below 1 Ω
O7-1 - Body ground Always 10 kΩ or higher


Standard Resistance:
RH Side
Tester Connection Condition Specified Condition
P7-1 - P20-4 (R CL) Always Below 1 Ω
P7-1 - Body ground Always 10 kΩ or higher




OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR