Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM27L0U _58 Vehicle Interior _049344 HEATING / AIR CONDITIONING _0235901 AIR CONDITIONING SYSTEM C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  B1441/41  Air Mix Damper Control Servo Motor Circuit (Passenger Side)  


DESCRIPTION

The air mix damper servo (for passenger side) sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the air mix damper servo (for passenger side) to any position. As a result, the amount of air that has passed through the evaporator and is now passing through the heater core is adjusted, and the temperature of the air blowing toward the passenger side is controlled.

DTC Code DTC Detection Condition Trouble Area
B1441/41 Air mix damper position sensor value does not change even if air conditioning amplifier operates air mix servo motor
·

Air mix damper servo (for passenger side)

·

Air conditioning harness

·

Air conditioning amplifier



WIRING DIAGRAM

E156865E22
1.387,0.438 1.835,0.580 0.448,0.142 10 SiG. A 1.387,0.735 1.835,0.877 0.448,0.142 10 SiG. B 1.439,1.104 1.796,1.246 0.357,0.142 10 GND 2.412,0.292 2.540,0.448 0.128,0.156 10 2 2.412,0.593 2.540,0.749 0.128,0.156 10 3 2.412,0.92 2.540,1.076 0.128,0.156 10 1 2.412,1.238 2.540,1.393 0.128,0.156 10 4 2.412,1.553 2.540,1.709 0.128,0.156 10 5 2.74,0.292 2.868,0.448 0.128,0.156 10 2 2.74,0.593 2.868,0.749 0.128,0.156 10 3 2.74,0.92 2.868,1.076 0.128,0.156 10 1 2.74,1.238 2.868,1.393 0.128,0.156 10 4 2.74,1.553 2.868,1.709 0.128,0.156 10 5 5.347,0.831 5.482,0.987 0.135,0.156 10 3 5.338,1.46 5.466,1.616 0.128,0.156 10 2 5.353,0.176 5.481,0.332 0.128,0.156 10 4 3.192,0.93 3.389,1.072 0.198,0.142 10 IC 0.697,1.976 2.518,2.299 1.820,0.323 10 Air Mix Damper Servo (for Passenger Side) 5.529,2.067 6.826,2.413 1.297,0.346 10 Air Conditioning Amplifier 5.531,1.921 5.867,2.077 0.336,0.156 10 z13 2.842,2.081 5.317,2.230 2.475,0.149 10 Air Conditioning Harness Assembly 5.594,0.295 6.118,0.451 0.524,0.156 10 B BUS 5.594,0.925 5.993,1.081 0.399,0.156 10 BUS 5.594,1.57 6.120,1.726 0.526,0.156 10 BUS G

PROCEDURE

1.READ VALUE USING TECHSTREAM (AIR MIX SERVO TARG PULSE (P))
a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Data List / Air Mix Servo Targ Pulse (P).


e.

According to the display on the Techstream, read the Data List.

Air Conditioner
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
Air Mix Servo Targ Pulse (P) Passenger side air mix servo motor target pulse /
Min.: 0
Max.: 255
MAX. COLD: 105 (pulse)
MAX. HOT: 6 (pulse)
-

OK:

The display is as specified in the normal condition.


Result
Result Proceed to
OK (When troubleshooting according to the DTC output) A
OK (When troubleshooting according to Problem Symptoms Table) B
NG C



A

2.REPLACE AIR MIX DAMPER SERVO (for Passenger Side)

B

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

C

2.REPLACE AIR MIX DAMPER SERVO (for Passenger Side)
a.

Temporarily replace the air mix damper servo (for passenger side) with a new one (See page Vehicle Interior>HEATING / AIR CONDITIONING>FRONT AIR CONDITIONING UNIT>DISASSEMBLY).

HINT:

Since the damper servo cannot be inspected while it is removed from the vehicle, replace the damper servo with a new one and check that the condition returns to normal.




NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC

OK

END (AIR MIX DAMPER SERVO IS DEFECTIVE)

NG

4.REPAIR OR REPLACE AIR CONDITIONING HARNESS
4.REPAIR OR REPLACE AIR CONDITIONING HARNESS
a.

Repair or replace the air conditioning harness (See page Vehicle Interior>HEATING / AIR CONDITIONING>FRONT AIR CONDITIONING UNIT>DISASSEMBLY).



NEXT

5.CHECK FOR DTC