Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING AMPLIFIER
RM27L0U _58 Vehicle Interior _049344 HEATING / AIR CONDITIONING _0235903 AIR CONDITIONING AMPLIFIER A

HEATING / AIR CONDITIONING  AIR CONDITIONING AMPLIFIER  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 67913 3.REMOVE FRONT DOOR SCUFF PLATE RH

Hide 62111C 4.REMOVE COWL SIDE TRIM BOARD RH

Hide 55607 6.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55045A 9.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY RH

Hide 88650E 10.REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY

I104452

a.

Disconnect the 3 connectors.


b.

Remove the 2 screws and amplifier.