Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING SYSTEM
RM27L0U _58 Vehicle Interior _049344 HEATING / AIR CONDITIONING _0235901 AIR CONDITIONING SYSTEM C

HEATING / AIR CONDITIONING  AIR CONDITIONING SYSTEM  B1443/43  Air Outlet Damper Control Servo Motor Circuit  


DESCRIPTION

The mode damper servo sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the air outlet damper to any position, which controls the air outlet switching.

HINT:

Confirm that no mechanical problem is present because this diagnostic trouble code can be output when either a damper link or damper is mechanically locked.


DTC Code DTC Detection Condition Trouble Area
B1443/43 Air outlet damper position sensor value does not change even if air conditioning amplifier operates air outlet servo motor
·

Cooling unit damper servo sub-assembly (Air outlet damper servo)

·

Air conditioning harness

·

Air conditioning amplifier



WIRING DIAGRAM

E156865E24
1.387,0.458 1.835,0.600 0.448,0.142 10 SiG. A 1.387,0.754 1.835,0.896 0.448,0.142 10 SiG. B 1.439,1.123 1.796,1.265 0.357,0.142 10 GND 2.412,0.312 2.540,0.468 0.128,0.156 10 2 2.412,0.613 2.540,0.769 0.128,0.156 10 3 2.412,0.94 2.540,1.096 0.128,0.156 10 1 2.412,1.257 2.540,1.413 0.128,0.156 10 4 2.412,1.573 2.540,1.729 0.128,0.156 10 5 2.74,0.312 2.868,0.468 0.128,0.156 10 2 2.74,0.613 2.868,0.769 0.128,0.156 10 3 2.74,0.94 2.868,1.096 0.128,0.156 10 1 2.74,1.257 2.868,1.413 0.128,0.156 10 4 2.74,1.573 2.868,1.729 0.128,0.156 10 5 5.352,0.222 5.495,0.377 0.144,0.155 10 4 5.352,0.846 5.466,1.001 0.114,0.155 10 3 5.352,1.474 5.455,1.629 0.103,0.155 10 2 3.192,0.95 3.389,1.092 0.198,0.142 10 IC 0.032,2.01 2.735,2.374 2.702,0.364 10 Cooling Unit Damper Servo Sub-Assembly (Air Outlet Damper Servo) 5.573,2.094 6.778,2.420 1.205,0.326 10 Air Conditioning Amplifier 5.573,1.934 5.914,2.090 0.341,0.156 10 z13 3.202,2.101 4.846,2.333 1.644,0.232 10 Air Conditioning Harness 5.594,0.315 6.215,0.471 0.621,0.156 10 B BUS 5.594,0.945 5.993,1.101 0.399,0.156 10 BUS 5.594,1.59 6.132,1.746 0.538,0.156 10 BUS G

PROCEDURE

1.READ VALUE USING TECHSTREAM (AIR OUTLET SERVO MOTOR TARGET PULSE)
a.

Connect the Techstream to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the Techstream on.


d.

Enter the following menus: Body Electrical / Air Conditioner / Data List / Air Outlet Servo Pulse (D).


e.

According to the display on the Techstream, read the Data List.

Air Conditioner
Tester Display Measurement Item / Range Normal Condition Diagnostic Note
Air Outlet Servo Pulse (D) Driver side air outlet servo motor target pulse /
Min.: 0
Max.: 255
FACE: 9 (pulse)
B/L: 32 (pulse)
FOOT: 56 (pulse)
FOOT/DEF: 83 (pulse)
DEF: 97 (pulse)
-

OK:

The display is as specified in the normal condition.


Result
Result Proceed to
OK (When troubleshooting according to the DTC output) A
OK (When troubleshooting according to Problem Symptoms Table) B
NG C



A

2.REPLACE COOLING UNIT DAMPER SERVO SUB-ASSEMBLY (AIR OUTLET DAMPER SERVO)

B

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

C

2.REPLACE COOLING UNIT DAMPER SERVO SUB-ASSEMBLY (AIR OUTLET DAMPER SERVO)
a.

Temporarily replace the cooling unit damper servo sub-assembly with a new one (See page Vehicle Interior>HEATING / AIR CONDITIONING>FRONT AIR CONDITIONING UNIT>DISASSEMBLY).

HINT:

Since the damper servo cannot be inspected while it is removed from the vehicle, replace the damper servo with a new one and check that the condition returns to normal.




NEXT

3.CHECK FOR DTC
3.CHECK FOR DTC

OK

END (AIR OUTLET DAMPER SERVO IS DEFECTIVE)

NG

4.REPAIR OR REPLACE AIR CONDITIONING HARNESS
4.REPAIR OR REPLACE AIR CONDITIONING HARNESS
a.

Repair or replace the air conditioning harness (See page Vehicle Interior>HEATING / AIR CONDITIONING>FRONT AIR CONDITIONING UNIT>DISASSEMBLY).



NEXT

5.CHECK FOR DTC