The air mix damper servo (for driver side) sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the air mix damper (for driver side) to any position. As a result, the amount of air that has passed through the evaporator and is now passing through the heater core is adjusted, and the temperature of the air blowing toward the driver side is controlled.
Confirm that no mechanical problem is present because this diagnostic trouble code can be output when either a damper link or damper is mechanically locked.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1446/46 | Air mix damper position sensor value does not change even if air conditioning amplifier operates air mix servo motor | ·
Cooling unit damper servo sub-assembly (Air mix damper servo (for driver side)) ·
Air conditioning harness ·
Air conditioning amplifier |
Connect the Techstream to DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Air Conditioner / Data List / Air Mix Servo Targ Pulse (D).
According to the display on the Techstream, read the Data List.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
|---|---|---|---|
| Air Mix Servo Targ Pulse (D) | Driver side air mix servo motor target pulse /
Min.: 0 Max.: 255 |
MAX. COLD: 5 (pulse)
MAX. HOT: 104 (pulse) |
- |
The display is as specified in the normal condition.
| Result | Proceed to |
|---|---|
| OK (When troubleshooting according to the DTC output) | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| NG | C |
A
B
(See pageVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>PROBLEM SYMPTOMS TABLE)
C
Temporarily replace the cooling unit damper servo sub-assembly (air mix damper servo) with a new one (See page Vehicle Interior>HEATING / AIR CONDITIONING>FRONT AIR CONDITIONING UNIT>DISASSEMBLY).
Since the damper servo cannot be inspected while it is removed from the vehicle, replace the damper servo with a new one and check that the condition returns to normal.
NEXT
Clear the DTC (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>DTC CHECK / CLEAR).
Check for DTC (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>DTC CHECK / CLEAR).
DTC is not output.
OK
NG
Repair or replace the air conditioning harness (See pageVehicle Interior>HEATING / AIR CONDITIONING>FRONT AIR CONDITIONING UNIT>DISASSEMBLY ).
NEXT
Clear the DTC (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>DTC CHECK / CLEAR).
Check for DTC again (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>DTC CHECK / CLEAR).
DTC is not output.
OK
NG