The cool air bypass damper servo sends pulse signals to inform the air conditioning amplifier of the damper position. The air conditioning amplifier activates the motor (normal, reverse) based on the signals to move the cool air bypass damper servo to any position. As a result, when the air conditioner is operating, the temperature of the air blowing toward the passenger's head area is controlled.
Although the Techstream title says "Passenger Side", there is only one cool air bypass servo motor on this vehicle.
Confirm that no mechanical problem is present because this diagnostic trouble code can be output when either a damper link or damper is mechanically locked.
| DTC Code | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1445/45 | Cool air bypass servo motor position sensor value does not change even if air conditioning amplifier operates cool air bypass servo motor | ·
Cool air bypass damper servo ·
Air conditioning harness ·
Air conditioning amplifier |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream on.
Enter the following menus: Body Electrical / Air Conditioner / Active Test / Cool Air Bypass Pulse.
While performing the Active Test, confirm that the air blown from the front center and front side registers changes in temperature.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Cool Air Bypass Pulse | Driver side cool air bypass pulse | Min.: 0
Max.: 255 |
- |
Air temperature changes in response to the operation of the cool air bypass servo motor.
| Result | Proceed to |
|---|---|
| NG | A |
| OK (When troubleshooting according to Problem Symptoms Table) | B |
| OK (When troubleshooting according to the DTC output) | C |
A
B
(See pageVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>PROBLEM SYMPTOMS TABLE)
C
Temporarily replace the cool air bypass damper servo with a new one (See page Vehicle Interior>HEATING / AIR CONDITIONING>FRONT AIR CONDITIONING UNIT>DISASSEMBLY).
Since the damper servo cannot be inspected while it is removed from the vehicle, replace the damper servo with a new one and check that the condition returns to normal.
NEXT
Clear the DTC (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>DTC CHECK / CLEAR).
Check for DTC (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>DTC CHECK / CLEAR).
DTC is not output.
OK
NG
Repair or replace the air conditioning harness (See page Vehicle Interior>HEATING / AIR CONDITIONING>FRONT AIR CONDITIONING UNIT>DISASSEMBLY).
NEXT
Clear the DTC (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>DTC CHECK / CLEAR).
Check for DTC again (See page Vehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>DTC CHECK / CLEAR).
DTC is not output.
OK
NG