1.RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
16361A
2.REMOVE FAN & GENERATOR V BELT
Remove the fan and generator V belt (See page Engine / Hybrid System>3UR-FE ENGINE MECHANICAL>DRIVE BELT>REMOVAL).
53886G
3.REMOVE FENDER APRON MUDGUARD SEAL LH
Remove the 6 clips and seal.
88712
4.DISCONNECT NO. 1 COOLER REFRIGERANT SUCTION HOSE
Remove the bolt and disconnect the cooler refrigerant suction hose from the cooler compressor.
Remove the O-ring from the cooler refrigerant suction hose.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
88711
5.DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE
Remove the bolt and disconnect the cooler refrigerant discharge hose from the cooler compressor.
Remove the O-ring from the cooler refrigerant discharge hose.
Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.
88320
6.REMOVE COOLER COMPRESSOR ASSEMBLY
Disconnect the connector.
Remove the 2 bolts and 2 nuts.
Remove the 2 stud bolts and cooler compressor.