Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM27L0U _59 Vehicle Exterior _049347 WINDOW / GLASS _0235939 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Back Door Glass goes Down During Auto Up Operation  


DESCRIPTION

If the door glass or the power window regulator does not smoothly operate, the jam protection function may operate abnormally, resulting in this symptom.

PROCEDURE

1.PERFORM INITIALIZATION
a.

Initialize the back door window regulator motor (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION).


b.

Check that the AUTO UP/DOWN function operates normally.

OK:

Back door power window AUTO UP/DOWN operates normally.




OK

END

NG

2.CHECK BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY
2.CHECK BACK DOOR POWER WINDOW REGULATOR MOTOR ASSEMBLY
a.

Remove the back door glass.


b.

Operate the power window regulator via the back door power window switch while the back door glass is not installed.


c.

Check that the power window regulator operates smoothly.

OK:

Power window moves smoothly.




OK

REPLACE BACK DOOR GLASS RUN

NG

REPLACE BACK DOOR POWER WINDOW REGULATOR MOTOR