Home › Vehicle Exterior › WINDOW / GLASS › QUARTER WINDOW GLASS
RM27L0U _59 Vehicle Exterior _049347 WINDOW / GLASS _0235950 QUARTER WINDOW GLASS A

WINDOW / GLASS  QUARTER WINDOW GLASS  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for both the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 3.REMOVE ROOF HEADLINING ASSEMBLY (w/o Rear Seat Entertainment System)

a.

Remove the roof headlining assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).


Hide 4.REMOVE ROOF HEADLINING (w/ Rear Seat Entertainment System)

a.

Remove the roof headlining assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).


Hide 5.REMOVE ROOF HEADLINING (w/ Sliding Roof)

a.

Remove the roof headlining assembly (See page Vehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL).


Hide 62440 6.REMOVE ROOF SIDE RAIL GARNISH ASSEMBLY

a.
B194339

Disengage the 4 clips and remove the roof side rail garnish.


Hide 62740B 7.REMOVE QUARTER WINDOW GLASS

B194340E01
1.723,2.024 2.719,2.190 0.996,0.166 10 Protective Tape 1.14,4.312 1.842,4.464 0.701,0.152 10 Piano Wire 2.324,4.261 2.012,4.415 false 2.048,1.449 2.285,2 false

a.

Apply protective tape to the outer circumference of the quarter window, as shown in the illustration.


b.

From the interior, insert piano wires between the vehicle body and quarter window, as shown in the illustration.


c.

Tie objects that can serve as handles (for example, wooden blocks) to all wire ends.

NOTICE:

When separating the quarter window from the vehicle, do not damage the vehicle's paintwork or exterior/interior ornaments.



d.

Cut through the adhesive by pulling the piano wire around the quarter window.