Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF HOUSING
RM27L0U _59 Vehicle Exterior _049348 SLIDING ROOF / CONVERTIBLE _0235953 SLIDING ROOF HOUSING A

SLIDING ROOF / CONVERTIBLE  SLIDING ROOF HOUSING  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 63311C 3.REMOVE ROOF HEADLINING ASSEMBLY

a.

Hide 62170A 4.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY RH

Hide 62180A 5.REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

HINT:

Use the same procedure for the RH side and LH side.


Hide 63217K 6.REMOVE SLIDING ROOF SIDE GARNISH RH

a.
B231299

Detach the 6 claws and remove the side garnish.


Hide 63218M 7.REMOVE SLIDING ROOF SIDE GARNISH LH

HINT:

Use the same procedure for the RH side and LH side.


Hide 63201G 8.REMOVE SLIDING ROOF GLASS SUB-ASSEMBLY

B191413

a.

Using a "TORX" socket wrench T25, remove the 4 bolts and glass.


Hide 63251H 9.REMOVE SLIDING ROOF WEATHERSTRIP

a.
B191802

Remove the sliding roof weatherstrip.


Hide 63203F 10.REMOVE SLIDING ROOF HOUSING SUB-ASSEMBLY

a.

Disconnect the 4 sliding roof drain hoses.


b.

Remove the 10 bolts, 6 nuts and housing.

B191414