Home › Vehicle Exterior › DOOR / HATCH › HOOD LOCK CONTROL CABLE ASSEMBLY
RM27L0U _59 Vehicle Exterior _049349 DOOR / HATCH _0235957 HOOD LOCK CONTROL CABLE ASSEMBLY A

DOOR / HATCH  HOOD LOCK CONTROL CABLE ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 53630 1.INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY

a.

Pass the hood lock control cable assembly into the engine compartment.


b.

Pass the cable rear side through the grommet until the cable stopper is attached to the grommet.


c.

Pass the cable front side through the upper radiator support.


d.

Engage the cable to the clamps as shown in the illustration.

B192512E01
1.913,3.213 2.319,3.370 0.405,0.157 10 Cable 3.527,1.782 3.932,1.939 0.405,0.157 10 Cable 5.763,3.349 6.168,3.507 0.405,0.157 10 Cable 5.125,0.744 5.530,0.901 0.405,0.157 10 Cable 2.641,0.539 3.046,0.696 0.405,0.157 10 Cable 2.599,0.618 2.49,0.861 false 5.533,0.822 5.667,1.028 false 3.918,1.852 4.166,2.057 false 6.175,3.418 6.253,3.938 false 2.126,3.028 2.126,3.197 false


Hide 53601 2.INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

a.
B192511

Connect the hood lock control cable assembly to the hood lock control lever sub-assembly.


b.

engage the 3 claws to install the hood lock lever


Hide 53510 3.INSTALL HOOD LOCK ASSEMBLY

a.
B166025

Apply MP grease to the sliding areas of the lock.


b.

Connect the connector.


c.
B192509

Connect the hood lock control cable.


d.

Install the hood lock.


e.

Install the 2 bolts and nut.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)

i.

Adjust the hood lock (See page Vehicle Exterior>DOOR / HATCH>HOOD>ADJUSTMENT).


ii.

Inspection the hood lock (See page Vehicle Exterior>DOOR / HATCH>HOOD>ADJUSTMENT).



f.
B192508

Install a new hood lock nut cap.


Hide 53629 4.INSTALL HOOD LOCK CONTROL CABLE COVER

a.
B360703

Attach the clamp to install the hood lock control cable cover.


b.

Install the 2 screws.