Home › Vehicle Exterior › WIPER / WASHER › REAR WIPER MOTOR
RM27L0U _59 Vehicle Exterior _049351 WIPER / WASHER _0235979 REAR WIPER MOTOR A

WIPER / WASHER  REAR WIPER MOTOR  INSTALLATION  


PROCEDURE

Hide 85143R 1.INSTALL REAR WIPER MOTOR GROMMET

E139081E02
1.358,0.949 2.057,1.088 0.699,0.139 10 MP grease 1.438,0.692 1.775,0.955 1.775,0.955 2.062,0.708 false

a.

Apply MP grease to the entire surface of the wiper motor grommet lip.

HINT:

Make sure that the hole does not get clogged with grease and the grooves on the lip are filled with grease.



b.
E162547E01
1.236,0.196 1.989,0.396 0.753,0.200 10 Upper Side

Install the rear wiper motor grommet with the mark directed up.


Hide 85110R 2.INSTALL REAR WIPER MOTOR ASSEMBLY

a.
E161698

Install the rear wiper motor with the 3 bolts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


b.

Connect the connector and clamp.


Hide 3.INSTALL REAR WIPER BLADE ASSEMBLY

a.
E345007E01
1.135,3.135 0.948,2.823 false 1.917,3.365 2.385,3.271 false 0.417,0.635 1.115,1.031 0.698,0.396 10 false Wiper Arm Serrations 0.219,2.719 1.75,2.917 1.531,0.198 10 false Wire Brush 2.448,3.104 3.167,3.49 0.719,0.385 10 false Wiper Pivot Serrations

Scrape any metal powder off the serrated part of the wiper arm with a round file or the equivalent (when reinstalling).


b.

Clean the wiper pivot serrations with a wire brush.


c.

Operate the wiper, and then stop the windshield wiper motor in the automatic stop position.


d.
E162548E01
1.216,1.745 2.135,1.914 0.919,0.169 10 Blade Position 0.824,1.534 1.166,1.823 false

Install the rear wiper arm into the position shown in the illustration with the nut.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)

NOTICE:

Position the rear wiper arm on the linear wiper step before tightening the nut.


HINT:

Hold the arm hinge down by hand while tightening the nut.



Hide 85292A 4.INSTALL REAR WIPER ARM HEAD CAP

a.
E161700

Engage the claw and install the rear wiper head cap.


Hide 67847A 5.INSTALL BACK DOOR SERVICE HOLE COVER

Hide 67750 6.INSTALL BACK DOOR TRIM BOARD ASSEMBLY

Hide 67961 7.INSTALL BACK DOOR PULL STRAP

Hide 67963A 8.INSTALL BACK DOOR STRAP COVER

Hide 67938A 9.INSTALL BACK DOOR SIDE GARNISH LH

Hide 67937B 10.INSTALL BACK DOOR SIDE GARNISH RH

Hide 67939B 11.INSTALL BACK DOOR CENTER GARNISH

Hide 85475 12.INSTALL POWER BACK DOOR ROD (w/ Power Back Door)