53932B
1.REMOVE FRONT END PANEL LH (w/o Headlight Cleaner System)
53931B
2.REMOVE FRONT END PANEL RH (w/o Headlight Cleaner System)
Use the same procedure described for the LH side.
53932B
3.REMOVE FRONT END PANEL LH (w/ Headlight Cleaner System)
53931B
4.REMOVE FRONT END PANEL RH (w/ Headlight Cleaner System)
Use the same procedure described for the LH side.
52119A
5.REMOVE FRONT BUMPER COVER
Apply protective tape as shown in the illustration.
| *1 | Protective Tape |
Using a screwdriver, turn each pin hold clip 90° remove the 2 pin hold clips.
Use the same procedure for the RH side and LH side.
Using a clip remover, remove the clip.
Use the same procedure for the RH side and LH side.
Remove the screw.
Use the same procedure for the RH side and LH side.
Remove the 8 clips.
Remove the 7 screws.
Detach the 4 claws and remove the front bumper cover.
Disconnect the connectors.
This procedure is only necessary for vehicles equipped with fog lights or the intuitive parking assist system.