Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM
RM27L0U _53 Suspension _049319 TIRE PRESSURE MONITORING _0235729 TIRE PRESSURE WARNING SYSTEM Y

TIRE PRESSURE MONITORING  TIRE PRESSURE WARNING SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use these procedures to troubleshoot the tire pressure warning system.

·

*: Use the Techstream.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.CUSTOMER PROBLEM ANALYSIS
2.CUSTOMER PROBLEM ANALYSIS
a.

Interview the customer to confirm the trouble.

HINT:

It is important to collect as much specific information as possible from the customer to allow for a quick repair.



Result:
Proceed to
NEXT



NEXT

3.ADJUST TIRE PRESSURE*
3.ADJUST TIRE PRESSURE*
a.

Turn the ignition switch off.


b.

Connect the Techstream to the DLC3.


c.

Turn the ignition switch to ON and turn the Techstream on.


d.

Enter the following menus: Chassis / Tire Pressure Monitor / Data List.


e.

Read the "ID Tire Inflation Pressure" values.


f.

Adjust all tire pressures to the standard values.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>PRECAUTION


g.

Check the Data List.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST

HINT:
·

It may take up about 5 to 6 minutes to display the updated tire pressure data.

·

If the problem is that the tire pressure decreases, wait until all of the tire pressure data is received by the ECU. If the data is received, the tire pressure warning light will turn off.




Result:
Result Proceed to
Tire pressure warning light remains on. A
Tire pressure warning light goes off. B



A

4.CHECK FOR DTC*

B

9.CONFIRMATION TEST*
4.CHECK FOR DTC*

Result:
Result Proceed to
DTC is output A
DTC is not output B



A

5.DTC CHART

B

6.PROBLEM SYMPTOMS TABLE
5.DTC CHART

Result:
Proceed to
NEXT



NEXT

8.REPAIR OR REPLACE
6.PROBLEM SYMPTOMS TABLE

Result:
Proceed to
NEXT



NEXT

7.CIRCUIT INSPECTION*
7.CIRCUIT INSPECTION*

Result:
Proceed to
NEXT



NEXT

8.REPAIR OR REPLACE
8.REPAIR OR REPLACE
a.

Repair or replace parts based on the diagnosis result.


Result:
Proceed to
NEXT



NEXT

9.CONFIRMATION TEST*
9.CONFIRMATION TEST*
a.

Check the Data List to confirm that the tire inflation pressure data has been received.

Click hereSuspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DATA LIST / ACTIVE TEST



c.

Confirm that the initialization has been completed.


Result:
Proceed to
NEXT



NEXT

END