CHECK DTC (USING THE TECHSTREAM)
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
Read the DTCs following the prompts on the Techstream screen.
Refer to the Techstream operator's manual for further details.
CHECK DTC (USING SST CHECK WIRE)
Turn the ignition switch off.
Using SST, connect terminals 13 (TC) and 4 (CG) of the DLC3.
Turn the ignition switch to ON.
Read and record any DTCs from the tire pressure warning light on the combination meter. Refer to the illustration above for examples of a normal system code and codes 13 and 33.
If 2 or more malfunctions are indicated at the same time, the lowest numbered DTC is displayed first.
Refer to Diagnostic Trouble Code Chart (See page Suspension>TIRE PRESSURE MONITORING>TIRE PRESSURE WARNING SYSTEM>DIAGNOSTIC TROUBLE CODE CHART) for DTC information.
After completing the check, turn the ignition switch off and remove SST from the DLC3.
CLEAR DTC
After repairing the malfunctions, clear the DTCs.
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream on.
Enter the following menus: Chassis / Tire Pressure Monitor / Trouble Codes.
Clear the DTCs following the prompts on the Techstream screen.
Refer to Techstream operator's manual for further details.